Test and adjustment values for gap dimensions
Number | Designation | Model | |||
BE60.00-P-1001-01I | Gap dimension | Fender/headlamps | Dimension "A" | mm | 2 (0.5) |
Engine hood to headlamp | Dimension "B" | mm | 4 (0.5) | ||
Bumper to headlamp | Dimension "C" | mm | 2 (0.5) | ||
Fender to side headlamps | Dimension "D" | mm | 2 (0.5) | ||
Fender to engine hood | Dimension "E" | mm | 4 (0.5) | ||
See picture | |||||
BE60.00-P-1002-01I | Gap dimension | Front door to A-pillar | Dimension "F" | mm | 5 (1) |
Roof to side roof frame | |||||
for glass | Dimension "G" | mm | 6 (2) | ||
for sheet metal | Dimension "G" | mm | 6 (1.5) | ||
Doors to side roof frame | Dimension "I" | mm | 5 (1) | ||
Door shells to side roof frame | Dimension "I1" | mm | 25 (1) | ||
Front door to rear door | Dimension "N" | mm | 4 (+1) | ||
Front door to fender | Dimension "Q" | mm | 4 (+1) | ||
See picture | |||||
BE60.00-P-1003-01I | Gap dimension | Rear fender to C-pillar | Dimension "H" | mm | 4 (0.5) |
Rear fender to trunk lid | Dimension "J" | mm | 4 (0.5) | ||
Rear fender to rear door | Dimension "K" | mm | 4 (0.5) | ||
Rear fender to bumper | Dimension "L" | mm | 2.8 (0.5) | ||
Rear fender to rear lamp unit | Dimension "M" | mm | 2 (0.5) | ||
Bumper to taillamp | Dimension "O" | mm | 2 (0.5) | ||
Trunk lid to lower taillamp | Dimension "P" | mm | 5 (0.5) | ||
See picture | |||||
BE60.00-P-1004-01I | Gap dimension | Fuel filler flap | Dimension "R" | mm | 3.5 (1) |
See picture | |||||
Feeler gauge
129 589 03 21 00
P60.00-2243-06
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2244-06