Remove/install instrument cluster

AR54.30-D-6016TS

Remove/install instrument cluster

15.10.2018

Model

907, 910

Modification notes

01.10.2018

Method revised and picture added.

Operation steps 4 and 5

1

Instrument cluster

4

Lead seal

2

Extraction hook

5

Electrical connector

3

Opening

1

Instrument cluster

2

Extraction hook

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Perform commissioning of instrument cluster (1) using vehicle diagnosis system.

When replacing instrument cluster (1).



AD00.00-D-2000-06TS

2

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

3

Move steering wheel to rearmost and lowest position.

Model 907, 910
with code CL1 (Height and rake adjustable steering wheel)

4

Guide extraction hooks (2) with downward pointing angled ends into openings (3) of instrument cluster (1).


Insert extraction hooks (2) fully up to end stop.
Otherwise, there can be damage to the plastic disk or the housing of the instrument cluster (1) when pulling out the instrument cluster (1).

 WIS Service Media
wsm://04_ 201800_02
Operation steps 4 to 6 are shown.

 Extraction hook

*140589023300

5

Turn extraction hooks (2) by 90° so that the angled ends (arrows) of the extraction hooks (2) point towards the center of the instrument cluster (1).

6

Pull instrument cluster (1) out of instrument panel using extraction hooks (2) until the electrical connector (5) is accessible.

7

Remove lead seal (4).

Model 907, 910
with code J78 (Lead sealing speedometer drive)

 Installation: Replace lead seal (4).

8

Disconnect electrical connector (5) and remove instrument cluster (1).

9

Install in the reverse order.