P47.10-2917-09
Shown on model 177 with code U54 (Torsion-beam axle) and without code 916 (Fuel tank with large capacity - volume 1) |
1 | Fuel tank | 5 | Electrical connector | 9 | Fuel line | ||
2 | Screw | 6 | Fuel connections | 10 | Electrical line | ||
3 | Heat shield | 8 | Bolts | N118 | Fuel pump control unit | ||
4 | Ground cable |
P47.10-A019-09
Shown on model 177 with code M005 (Vehicles with 4MATIC/all-wheel drive) |
1 | Fuel tank | 8 | Bolts | 10 | Electrical line | ||
5 | Electrical connector | 9 | Fuel line | N118 | Fuel pump control unit | ||
6 | Fuel connections |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Notes on safety-relevant components | |||
| Remove | ||
1.1 | Empty fuel tank (1) with fuel pump. | If fuel pump is intact. | |
1.2 | Empty fuel tank (1) with tank emptying device. | With defective fuel pump. | |
2.1 | Remove propeller shaft from rear axle differential. | Model 118, 177, 247 with engine 654 | |
2.2 | Lower the exhaust system until fuel tank (1) can be removed. | Model 118, 177, 247 with engine 608 | |
Model 118, 177, 247 with engine 608 | |||
Model 118, 177, 247 with engine 654 | |||
3 | Remove trim of rear axle carrier. | Model 118, 177, 247 with engine 654 | |
4 | Unscrew screw (2) and remove ground line (4). | Model 118, 177, 247 with engine 608 | |
5 | Remove brackets and remove heat shield (3) downwards. | Model 118, 177, 247 with engine 608 | |
Clip remover | |||
6 | Release and disconnect electrical connector (5) at fuel system control unit (N118). | ||
7 | Remove electric line (10) from underbody. | Clip remover | |
8 | Remove filler neck from fuel tank (1). |
| |
Model 118, 177, 247 with engine 654 | |||
9 | Support fuel tank (1). | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
10 | Remove screws (8). | ||
11 | Lower fuel tank (1) and remove. | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
Aid of helper required. | |||
| Install | ||
12 | Lift fuel tank (1) and position on underbody. | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
Aid of helper required. | |||
13 | Screw in screws (8). | Bolt, fuel tank/tensioning strap for fuel tank to body | |
14 | Lower major assembly mount with mounting plate and move outside the working area. | ||
| 000 588 10 62 00 Support plate | ||
| 000 588 11 62 00 Major assembly mount | ||
15 | Install filler neck on fuel tank (1). |
| |
Model 118, 177, 247 with engine 654 | |||
16 | Attach electric line (10) to underbody. | ||
17 | Connect electrical connector (5) to fuel system control unit (N118) and lock. | ||
18 | Remove appropriate stop plugs. | Record plug | |
19 | Position fuel line (9) on fuel connections (6) and underbody. | ||
20 | Connect and lock fuel connections (6). | ||
21 | Position heat shield (3) on fuel tank (1) and install brackets. | Model 118, 177, 247 with engine 608 | |
22 | Attach ground line (4) and screw in screw (2). | Model 118, 177, 247 with engine 608 | |
Ensure correct routing of ground line (4). | |||
Bolt, fuel tank/tensioning strap for fuel tank to body | |||
23 | Install trim of rear axle carrier. | Model 118, 177, 247 with engine 654 | |
24.1 | Install exhaust system. | Model 118, 177, 247 with engine 608 | |
Model 118, 177, 247 with engine 608 | |||
Model 118, 177, 247 with engine 654 | |||
24.2 | Mount propeller shaft on rear axle differential. | Model 118, 177, 247 with engine 654 | |
25.1 | Fill fuel tank (1). | If fuel pump is intact. | |
25.2 | Fill fuel tank (1) with fuel in safety container. | With defective fuel pump. | |
452 589 01 63 00
Clip remover
129 589 00 91 00
Record plug
Powiązane dokumenty
- ah0000p500001a Wskazówki dotyczące zapobiegania uszkodzeniom na skutek zabrudzeń i ciał obcych
- ah0000z001901a Wskazówki dotyczące elementów wpływających na bezpieczeństwo
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ar4110p0050mfa
- ar4710p4000mfe Opróżnianie zbiornika paliwa w przypadku uszkodzonej pompy paliwowej
- ar4710p4001mfe
- ar4710p7541mfe Demontaż i montaż króćca wlewowego zbiornika paliwa
- ar4710p7541mff
- ar4910p7142mfe Demontaż i montaż układu wydechowego
- ar4910p7142mff
- ar6130p0050mfa
- as0000z000501a Niebezpieczeństwo wypadku na skutek samoczynnego ruszenia przy pracującym silniku. Niebezpieczeństwo obrażeń na skutek zmiażdżenia lub poparzenia przy wykonywaniu czynności podczas rozruchu lub przy pracującym silniku.
- as0000z000901a Niebezpieczeństwo zakleszczenia lub zmiażdżenia, w skrajnym przypadku obcięcia kończyn podczas prac przy układach mechanicznych.
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.
- as0000z001701a Niebezpieczeństwo obrażeńo elementy pojazdu o ostrych krawędziach.
- as4700z000101a Niebezpieczeństwo wybuchu wskutek zapalenia, niebezpieczeństwo zatrucia wskutek wdychania i połknięcia paliwa oraz niebezpieczeństwo obrażeń wskutek kontaktu skóry i oczu z paliwem.
- ws0100p0092b
- ws2600p3309b