P46.40-0208-06
10 Tie rod
10h Self-locking nut
11 Drag link
11e Self-locking nut
26 Steering idler arm
26a Screw
26b Self-locking nut
26c Dust cap
26d Spacer
26e Sealing disk
26f Rubber friction bearing
26g Heat shield
061 Puller
062 Insertion tool
| Remove, Install | ||
Installation | Replace self-locking nuts | ||
1 | Detach tie rod (10) at steering idler arm (26) | ||
2 | Detach drag link (11) at steering idler arm (26) | | |
3 | Remove heat shield (26g) | ||
4 | Unscrew nut (26b), remove washer (26e). Pull out bolt (26a) and remove steering idler arm (26) | | |
5 | Lift sealing lip at the slide bushing (26f) using a screwdriver and remove slide bushing from rubber mount | ||
6 | Use extractor (061) to pull out rubber friction bearing (26f) | Extractor | |
Installation: Use insertion tool to pull in rubber friction bearing as far as the stop | |||
Insertion tool | |||
7 | Install in the reverse order |
Steering idler arm
Number | Designation | Model 129 | ||
BA46.40-P-1001-05A | Self-locking nut, steering idler arm to longitudinal frame member bearing bracket | NM | 180 | |
129 589 00 33 00
115 589 08 61 00
Insertion tool
Puller