ar4110p0100tx

Remove/install propeller shaft intermediate bearing and replace grooved ball bearing

Typ ar · temat 41.10 · wersja 0103 · 2006-04-04

Dotyczy: MODEL 219

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 41 Wał napędowy › 41.10 Wał napędowy — Seria 219

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.40 Wał napędowy › 17.40.30 Wał napędowy napędu/ napędu na cztery koła — Seria 219

AR41.10-P-0100TX

Remove/install propeller shaft intermediate bearing and replace grooved ball bearing

31.3.06

MODEL 219

Remove/install propeller shaft intermediate bearing and replace grooved ball bearing

P41.10-2252-11

1 Front half of propeller shaft

2 Rear half of propeller shaft

4 Rubber boot

7b Rubber bushing

8 Grooved ball bearing

Remove/install

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Remove propeller shaft

AR41.10-P-0050TX

2

Separate front half of propeller shaft (1) and rear half of propeller shaft (2) at propeller shaft intermediate bearing

Installation: Coat splined profile with MB long-life grease.

Installation: Assemble the driveshaft.

AR41.10-P-0050-05TX

3

Pull rubber boot (4) off front half of propeller shaft (1)

Installation: Replace damaged rubber boot (4), paying attention to the correct seating.

4

Detach rubber mount (7b) together with grooved ball bearing (8) from front propeller shaft half (1)

AR41.10-P-0100-07TX

Installation: Press rubber mount (7b) together with the grooved ball bearing (8) onto the front propeller shaft half (1).

AR41.10-P-0100-05TX

5

Press grooved ball bearing (8) out of rubber mount (7b) of propeller shaft

AR41.10-P-0100-02TX

Checking

6

Check rubber boot (4), rubber mount (7b) and deep-groove ball bearing (8)

If damage is found during the visual inspection the relevant component must be replaced subject to separate repair order to prevent consequential damage.

7

Install in the reverse order

Powiązane dokumenty