| Check | ||
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
1 | Drive the vehicle to the measurement site | The vehicle should be measured on a horizontal, even and clean floor (if necessary, check with a hose level). A measurement site equipped with a workshop ditch is very beneficial. | |
2 | Check condition of the steering system mechanism | ||
| . | ||
3 | Check the articulations of the steering bar and track bar for play and check the rubber boots | ||
| . | ||
4 | Check the condition of the tires | The conditions of the tires can assist in indicating incorrect adjustment of the steering geometry and the alignment of the axles. | |
5 | Lift the vehicle by the front axle and support it on stands | Before lifting the vehicle, make sure that the parking brake is engaged and/or shim the rear wheels. | |
6 | Check front wheel bearing play |
| |
7 | Check the axle sleeve bearing play | The shaft sleeve must not be loaded. Trigger the service brake by locking the wheel, and then insert a lever into one of the wheel holes so that it is possible to push a force up and down the wheel. In this way, it can be observed if there is play in the bearings of the shaft sleeve. | |
8 | Check the tires for radial eccentricity |
| |
.Tire radial run-out with 22.5 wheel diameter (installed in vehicle) | |||
9 | Check the side offset of the wheel |
| |
.Warping/deformation on wheels with diameter of 22.5 (mounted on the vehicle) | |||
10 | Lower the vehicle | ||
11 | Rear axle - Check bearing clearance on longitudinal control arms | ||
| . | ||
12 | Check and adjust the vehicle height |
| |
Only if the value found is out of nominal measure. | |||
13 | Print the axle measurement form | ||
| . | ||
Record the measured values achieved on the following work steps on the form. | |||
14 | Check the tire inflation pressure | ||
| . | ||
| |||
If necessary: | |||
| |||
Reestablish tires inflation pressure, including spare wheel | |||
15 | Write down the brand, designation and size of the tires | ||
16 | Measure and write down the tire groove depth |
Powiązane dokumenty
- ap3510b3556a
- ap4015b406001xa
- ap4015b4060a
- ap4600b4650b
- ap4600b4653a
- ar3222b7000xb
- ar3320b0300c
- ar4010b102502a
- ar4010b102503a
- as0000z000901a Niebezpieczeństwo zakleszczenia lub zmiażdżenia, w skrajnym przypadku obcięcia kończyn podczas prac przy układach mechanicznych.
- of4020b300001a