P35.30-2132-07
1 Input shaft boot
2 Joint hub
5 Input shaft boot
6 Input shaft
3 Hose clamp
4 Hose clamp
| Removing | ||
1 | Remove input shaft (6) | ||
| Disassemble | ||
2 | Remove input shaft boot (5) at wheel end | ||
3 | Detach clamps (3, 4) | ||
4 | Cut open input shaft boot (1) and pull off | ||
| Clean | ||
5 | Clean joint hub (2) and inner spider | ||
| Assembly | ||
6 | Release input shaft (6) from vise and remove | ||
7 | Push new input shaft boot (1) onto input shaft in direction of arrow (6) | ||
8 | Push clamp (4) onto input shaft (6) | ||
9 | Clamp input shaft (6) in vise using protective jaws | ||
10 | Fill joint hub (2) with grease included in package contents | ||
11 | Push joint hub (2) onto input shaft (6) | ||
12 | Fill input shaft boot (1) and joint hub (2) with remaining grease | ||
13 | Push input shaft boot (1) onto joint hub (2) | The raised bead on the input shaft boot (1) must locate in the slot in the joint hub (2). | |
14 | Position clamps (3, 4) on input shaft boot (1) and secure | ||
15 | Release input shaft (6) from vise and remove | ||
| Install | ||
16 | Install input shaft boot (5) at wheel end | ||
17 | Install input shaft (6) |