P35.30-2131-07
1 Constant velocity joint
2 Input shaft boot
3 Vise
6 Input shaft
7 Circlip
4 Hose clamp
5 Hose clamp
| Removing | ||
1 | Remove input shaft (6) | ||
| Disassemble | ||
2 | Clamp input shaft (6) in vise (3) using protective jaws | ||
3 | Detach clamps (4, 5) | ||
4 | Cut open and pull off input shaft boot (2) and detach constant velocity joint (1) in direction of arrow from input shaft (6) | Drive the constant velocity joint (1) on the inner spider off the input shaft (6). Use a suitable steel drift. | |
5 | Remove circlip (7) | ||
| Clean | ||
6 | Clean constant velocity joint (1) | ||
| Assembly | ||
7 | Push clamp (4) onto input shaft (6) | ||
8 | Push new input shaft boot (2) onto input shaft (6) | ||
9 | Install new circlip (7). | ||
10 | Fill constant velocity joint (1) up to upper edge of inner spider with grease included in package contents | ||
11 | Push constant velocity joint (1) onto input shaft (6) | The constant velocity joint (1) must engage in circlip (7). | |
12 | Fill input shaft boot (2) and constant velocity joint (1) with remaining grease | ||
13 | Push input shaft boot (2) onto constant velocity joint (1) | The raised bead on the input shaft boot (2) must locate in the slot in the constant velocity joint (1). | |
14 | Position clamps (4, 5) on input shaft boot (2) and secure | ||
15 | Release input shaft (6) from vise (3) and remove | ||
| Install | ||
16 | Install input shaft (6) |