ar3530p062002tx

Extract/press in rear axle shaft from rear axle differential

Typ ar · temat 35.30 · wersja 0101 · 2006-04-24

Dotyczy: MODEL 219 HA-Mittelstück 198 MODEL 219 HA-Mittelstück 200 MODEL 219 HA-Mittelstück 215'

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 2 Podwozie › 35 Oś tylna › 35.30 Napęd, wały napędowe — Seria 219

EinPAS 17 Zespół przeniesienia napędu/ oś › 17.51 Oś tylna › 17.51.51 Półoś/ wałek napędowy — Seria 219

AR35.30-P-0620-02TX

Extract/press in rear axle shaft from rear axle differential

Extract/press in rear axle shaft from rear axle differential

P35.30-2020-01

Pull out rear axle shaft

1 Using a suitable tool (e.g. screwdriver, assembly lever), press rear axle shaft (37) out of the rear axle center assembly.

When pressing out the rear axle shaft (37), do not damage the radial sealing ring in order to prevent leakage. Rear axle shafts (37) with defective joints or boots must be replaced.

Extract/press in rear axle shaft from rear axle differential

P35.30-2021-01

Press in rear axle shaft

2 Press in rear axle shaft (37) until circlip (37g) is felt to engage.

Align the joint ring (37c) horizontally before inserting otherwise the splined profile may tilt and be damaged.

When pressing the rear axle shaft (37) into the rear axle center assembly, do not damage the radial sealing ring in order to prevent leakage. The joint ring (37c) must close flush with the rear axle housing.