Remove/install thrust arm · ar3520p0113tx · Mercedes-Benz WIS

AR35.20-P-0113TX

Remove/install thrust arm

19.4.06

MODEL 219.3

P35.20-2093-06

Shown on model 219 with steel suspension

1 Rear axle carrier

1c Bolt

1e Washer

5 Thrust arm

5g Thrust arm cover

7 Wheel carrier

16 Underbody paneling

37 Rear axle shaft

Modification notes

26.10.05

Self-locking bolt, front rear axle carrier rubber mount to frame floor

 	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected
	Tighten nuts and bolts of chassis components only when vehicle is in the ready-to-drive condition.
1	Raise vehicle with lifting platform		AR00.60-P-1000TX
2	Remove rear wheel
	Remove/install wheels, rotate if necessary		AP40.10-P-4050TX
3	Remove rear part of underfloor paneling (16).		AR61.30-P-1001TX
4	Remove bolt (1c) and take off washer (1e).		*BA35.10-P-1001-01J
5	Raise wheel carrier (7) using transmission jack and transmission platform until rear axle shaft (37) is roughly horizontal		*WE58.40-Z-1018-11A
			*WE58.40-Z-1030-11A
6	Detach thrust arm (5) from wheel carrier (7)	 Installation: The rear axle shaft (37) must be roughly horizontal when tightening the bolted connection in order not to not destroy the rubber mounts.
			*BA35.20-P-1002-05E
7	Detach thrust arm (5) from rear axle carrier (1).	 Installation: The rear axle shaft (37) must be roughly horizontal when tightening the bolted connection in order not to not destroy the rubber mounts.
			*BA35.20-P-1001-05E
8	Remove thrust arm cover (5g).
9	Install in the reverse order
10	Perform chassis alignment		AR40.20-P-0200TX

Rear axle carrier

Number	Designation			Model 219


BA35.10-P-1001-01J	Self-locking bolt, front rear axle carrier rubber mount to frame floor	Stage 1	Nm	90
		Stage 2	°	60

Torque strut

Number	Designation					Model 219


BA35.20-P-1001-05E	Self-locking nut, torque strut to rear axle carrier	Aluminum	M12	Stage 1	Nm	50
				Stage 2	°	90
		Steel	M14	Stage 1	Nm	80
				Stage 2	°	90
BA35.20-P-1002-05E	Self-locking nut, thrust arm to wheel carrier	Aluminum	M12	Stage 1	Nm	50
				Stage 2	°	90
		Steel	M14	Stage 1	Nm	80
				Stage 2	°	90

Workshop equipment

WE58.40-Z-1018-11A	Transmission platform
WE58.40-Z-1030-11A	Transmission jack