P35.15-2024-09
Shown on MODEL 453.3 |
1 | Control arm | 5 | Threaded rod | 9 | Nuts | ||
2 | Guide pin | 6 | Nut | 10 | Bolts | ||
3 | Screw | 7 | Rear axle crossmember | a | Clearance | ||
4 | Screw | 8 | Screw |
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Notes on self-locking nuts and bolts | ||
| Notes on repair work on suspension components | ||
| Remove | ||
1 | Detach rear complete wheels | ||
2 | Remove screws/bolts (3) | Do not unscrew bolts (4). | |
3 | Screw nuts (6) and shims onto suitable threaded rods (5) | Threaded rods (5) or bolts with a minimum length of 200 mm are to be used. | |
4 | Screw threaded rods (5) into threaded holes for bolts (3) | ||
5 | Adjust distance dimension (a) by turning the nuts (6) | Distance dimension (a): approx. 25 mm | |
6 | Remove bolts (4) alternately | Otherwise the rear axle crossmember (7) may become tilted on the threaded rods (5). | |
7 | Lower rear axle crossmember (7) by unfastening nuts (6) until it is free of tension | | |
8 | Unscrew left or right bolt (8) | ||
9 | Unscrew left or right nut (9) and remove washer | ||
10 | Pull out left or right bolt (10) and remove left or right control arm (1) | ||
| Install | ||
11 | Position appropriate control arm (1) on rear axle crossmember (7) and insert bolt (10) | ||
12 | Fit washer on bolt (10) and screw on nut (9) up to mounting surface | ||
13 | Position control arm (1) on axle tube and screw in bolt (8) up to mounting surface | ||
14 | Screw nuts (6) onto threaded rods (5) up to mounting surface of rear axle crossmember (7) on body | Screw in nuts (6) alternately on right and left sides to avoid tilting the rear axle crossmember (7) on the threaded rods (5). | |
15 | Tighten bolts (4) | Bolt, cross member for rear axle to body | |
16 | Unscrew threaded rods (5) from body | ||
17 | Tighten bolts (3) | Bolt, cross member for rear axle to body | |
18 | Mount rear complete wheels | ||
19 | Lower vehicle with vehicle lift | ||
20 | Counterhold nut (9) and tighten bolt (10) | The bolt (10) may only be tightened when the vehicle is completely lowered and the suspension is compressed. | |
Bolt, control arm to cross member on rear axle | |||
21 | Tighten bolt (8) | The bolt (8) may only be tightened when the vehicle is completely lowered and the suspension is compressed. | |
Bolt, control arm to rear axle tube | |||
22 | Perform wheel alignment check |
Powiązane dokumenty
- ah0000n000101a Wskazówki dotyczące samozabezpieczających śrub i nakrętek
- ah0000p010001a Wskazówki dotyczące napraw komponentów zawieszenia
- ar4010p1100sr
- ar4020p0200sr
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.