Remove/install anti-roll bar on rear axle

AR32.35-D-2210TS

Remove/install anti-roll bar on rear axle

28.05.2019

Model

907

Modification notes

28.05.2019

Screw, torsion bar linkage to stabilizer bar

BA32.35-N-1003-03TS

1

Stabilizer bar

4

Elastomer bearing

6

Screw

3

Screw

5

Bearing shell

7

Nut

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 

Remove/install

1

Lift vehicle with lifting platform.

AR00.60-D-1000-04TS

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

2

Remove stabilizer bar (1) from torsion bar linkage.

 To do so, remove bolts (6) and counterhold the nuts (7).

 Screw, torsion bar linkage to stabilizer bar

*BA32.35-N-1003-03TS

3

Remove stabilizer bar (1).

Topical note

Notes on threaded connections fastened using a tightening angle-based tightening process

AH00.00-P-0020-01A

 To do so, remove bolts (3) and remove stabilizer bar (1) with elastomer bearings (4) and bearing shells (5).

 Installation: Align stabilizer bar (1) in center.

 Installation: Check elastomer bearings (4) for damage.

 Bolt, stabilizer bar to rear axle

*BA32.35-N-1001-03TS

In the case of damage,



Replace elastomer bearing(4).

4

Install in the reverse order.

 Rear axle stabilizer bar

Number

Designation

Model 907 except code IT5

Model 907 with code IT5

BA32.35-N-1001-03TS

Bolt, stabilizer bar to rear axle

Stage 1

Nm

61

102

Stage 2

°

-

60

 Rear axle stabilizer bar

Number

Designation

Model 907 except code IT5

Model 907 with code IT5

BA32.35-N-1003-03TS

Screw, torsion bar linkage to stabilizer bar

Stage 1

Nm

50

50

Stage 2

°

90

90