Model | 907, 910 |
with code Q20 (Trailer hitch (jaw-type)) | |
Model | 907, 910 |
with code Q22 (Trailer coupling, rigid coupling head) | |
Model | 907, 910 |
with code Q24 (Trailer cross member NAFTA, towing capacity 5000Ibs) | |
Model | 907, 910 |
with code Q50 (Trailer coupling with removable ball-type head) | |
Model | 907, 910 |
with code QA7 (Trailer hitch for increased towing capacity 3.5 t) | |
Model | 907, 910 |
with code QA8 (Trailer hitch for increased towing capacity 2.8 t/3.0 t) |
D31.10-0031-09
Shown with CODE Q50 (Trailer hitch with removable ball head) |
1 | Trailer hitch | 3 | Plates | |
2 | Bolts |
Shown with CODE Q50 (Trailer hitch with removable ball head) |
1 | Trailer hitch |
4 | Ball head |
5 | Mounting plate |
6 | Bolts |
D31.10-0032-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Notes regarding work on trailer coupling | ||
Topical note | Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
2 | Detach electrical wiring harness from trailer hitch (1). | To do so, cut through the cable ties. | |
Installation: Replace cable ties. Check retaining clip. | |||
If corresponding findings are present, | |||
| |||
Replacing retaining clip. | |||
3 | Detach trailer socket from trailer hitch (1) and place outside working area. | ||
4 | Unscrew nuts of screws (2). | Bolt/nut, trailer hitch to longitudinal member | |
5 | Remove screws (2) with plates (3) from longitudinal members and remove trailer hitch (1). | Helper required. | |
6.1 | Detach ball head (4) from trailer hitch (1). | Model 907, 910 | |
Bolt/nut, ball head to crossmember on trailer hitch | |||
Nut, jaw-type coupling to trailer hitch crossmember | |||
6.2 | Detach ball head (4) from mounting plate (5). | Model 907, 910 | |
7 | Remove mounting plate (5). | Model 907, 910 | |
To do so, remove the bolts (6). | |||
Bolt, mounting plate to trailer hitch crossmember | |||
8 | Install in the reverse order |
Powiązane dokumenty
- ah0000n000101a Wskazówki dotyczące samozabezpieczających śrub i nakrętek
- ah0060n010001ts Wskazówki dotyczące podnoszenia pojazdu, ustawiania na podporach
- ah3110n100001a Wskazówki dotyczące prac przy haku holowniczym
- ar0060d100004ts
- ar3119d1200ts
- as0000z001001a Zagrożenie życia na skutek ześlizgnięcia lub spadnięcia pojazdu z podnośnika.