Model | 907, 910 |
with code Q20 (Trailer hitch (jaw-type)) | |
Model | 907, 910 |
with code Q22 (Trailer coupling, rigid coupling head) | |
Model | 907, 910 |
with code Q24 (Trailer cross member NAFTA, towing capacity 5000Ibs) | |
Model | 907, 910 |
with code Q50 (Trailer coupling with removable ball-type head) | |
Model | 907, 910 |
with code QA7 (Trailer hitch for increased towing capacity 3.5 t) | |
Model | 907, 910 |
with code QA8 (Trailer hitch for increased towing capacity 2.8 t/3.0 t) |
1 | Contact socket (electric line BK/WH, 0.75 mm2), left turn signal lamp) |
2 | Contact socket (electric line GY/WH, 0.75 mm2), rear fog lamp) |
3 | Contact socket (electric line BN, 1.5 mm2), ground connection tml. 31) |
4 | Contact socket (electric line BK/GN, 0.75 mm2), right turn signal lamp) |
5 | Contact socket (electric line GY/RD, 0.75 mm2), right tail lamp) |
6 | Contact socket (electric line BK/RD, 1.0 mm2), brake lamps) |
7 | Contact socket (electric line GY/BK, 0.75 mm2), left tail lamp) |
8 | Contact socket (electric line WH/BU, 0.75 mm2), reversing lamp) |
9 | Contact socket (electric line RD/YE, 2.5 mm2), power supply tml. 30) |
13 | Contact socket (electric line BN, 2.5 mm2), ground connection tml. 31) |
14 | Trailer socket |
15 | Bracket |
16 | Plug socket housing |
17 | Contact carrier |
18 | Cable lugs |
19 | Seal |
20 | Cap |
21 | Screw |
D31.10-0028-06
| Remove/install | ||
1 | Disconnect ground line of on-board electrical system battery | ||
2 | Unscrew screws (21) and guide trailer socket (14) sideways out of retaining plate | Installation: Make sure that the seal (19) and the cover (20) are seated correctly. | |
3 | Detach trailer socket (14) | To do so, open the cable tie. | |
Installation: Replace cable tie. | |||
4 | Release catches and open bracket(15) | Installation: Make sure that the sealing ring is seated correctly on the holder (15). | |
5 | Remove plug socket housing(16) from bracket(15) | ||
6 | Remove contact carrier (17) from connector housing (16) | ||
7 | Remove cable lugs(18) from contact carrier(17) | Installation: Make sure that the cable lugs (18) are correctly assigned to the contact sockets (1, 2, 3, 4, 5, 6, 7, 8, 9, 13). | |
8 | Install in the reverse order | ||
9 | Perform function test on trailer socket (14) | ||
| 000 588 00 63 00 Test box |