Remove/install radar sensor

AR30.30-D-1210TS

Remove/install radar sensor

14.08.2020

Model

907, 910

Modification notes

12.08.2020

Work procedure completely revised.

Shown on model 907.6 with code D51 (full-width partition wall with one window) and with code JB6 (Parking Package with 360° camera)

1

Radar sensor

4

Electrical wiring harness

2

Bolts

5

Radiator trim

3

Bracket

Shown on model 907.6 with code D51 (full-width partition wall with one window) and with code JB6 (Parking Package with 360° camera)

1

Radar sensor

3

Bracket

6

Retaining tab

7

Electrical connector

Topical note

Notes on preventing damage to electronic components due to a magnetic tool

AH54.00-P-0002-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Remove radiator grille (5).

AR88.40-D-4001TS

2

Unclip electrical wiring harness (4) from holder (3) (arrow A).

Model 907
with code JB6 (Parking package with 360-degree camera)

 Clip remover

*452589016300

3

Remove screws (2).

4

Release radar sensor (1) at retaining tab (6) and swivel forward in direction of arrow (arrow B) out of bracket (3).

5

Lift bracket (3) with radar sensor (1) far enough for electrical connector (7) to be accessible.

6

Disconnect electrical connector (7) and remove radar sensor (1) from bracket (3).

7

Install in the reverse order.

8

Commission radar sensor (1) with diagnostic system.



AD00.00-D-2000-06TS