ar0703d9105r

Remove/install leak oil line to injectors

Typ ar · temat 07.03 · wersja 0101 · 2013-09-26

Dotyczy: ENGINE 646 in MODEL 909

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 1 Silnik › 07 Przygotowanie mieszanki › 07.03 Wtryskiwacze, zawory wtryskiwaczy — Seria 646 · Seria 909

EinPAS 15 Silnik › 15.45 Sterowanie pracą silnika › 15.45.13 Przewód sztywny/elastyczny/zawór — Seria 646 · Seria 909

AR07.03-D-9105R

Remove/install leak oil line to injectors

11.09.2013

ENGINE

646 in MODEL 909

Remove/install leak oil line to injectors

1

Leak oil line

2

Lock

3

Fuel return line fitting

D07.03-1114-06

Danger !

Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.

No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only.
Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

Danger !

Risk of explosion caused by fuel igniting. Risk of injury to skin and eyes caused by fuel spraying out at high pressure

Keep all ignition sources out of hazard area.
Do not carry out any work on system when it is pressurized.

AS07.16-Z-0001-01A

Remove/install

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

1

Open engine hood

2

Remove cylinder head cover trim

AR01.20-D-5014-02R

Installation: Only install cylinder head cover trim panel after the leak test.

Bolt, trim panel to cylinder head cover

*BA01.20-N-1003-01M

3

Unlock lock (2) upwards using a suitable tool an all injectors

4

Detach the leak oil line (1) at all injectors

Installation: Install new sealing rings.

5

Lead out leak oil line (1) under the injection lines

6

Loosen leak oil line (1) from mounts and detach from fuel return line fitting (3)

7

Remove leak oil line (1)

Installation: Check leak oil line (1) and replace if necessary.

8

Install in the reverse order

Danger !

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

9

Perform an engine test run, stop engine and check fuel system in the area of leak oil line (1) for leaktightness

Crankcase ventilation, cylinder head cover

Number

Designation

ENGINE 646 in MODEL 909

BA01.20-N-1003-01M

Bolt, trim panel to cylinder head cover

Nm

10

Powiązane dokumenty