Secure vehicle on vehicle lift

AR00.60-P-0100SR

Secure vehicle on vehicle lift

21.06.2017

Model

453

Modification notes

27.04.2017

Securing method completely revised.

Shown on front left side of vehicle

1

Tensioning strap

2

Front vehicle lift swivel arm

3

Carrier

4

Seat belt buckle

5

Rear vehicle lift swivel arm

Model 453.3/4 except for code J59 (center armrest)

6

Cup holder

Shown on model 453.0 rear

5

Rear vehicle lift swivel arm

7

Tensioning strap

Shown on model 453.3 rear

5

Rear vehicle lift swivel arm

7

Tensioning strap

8

Belt buckle

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A



Check

1

Check the turntables of the vehicle lift for damage

 The turntables of the vehicle lift must not be damaged.

In case of damage



Replace a defective turntable.

Securing

2

Lift vehicle on vehicle lift

Model 453.091/391/491

 Align the turn plates so that the screws of the rubber pads on the turn plates cannot come into contact with vehicle parts while jacking up.

3

Guide or suspend the tensioning strap (1) as shown over the carrier (3) and around the front vehicle lift swivel arm (2)

 Depending on the version of the tensioning strap (1) used.

 Use tensioning strap (1) with following properties:
Maximum elongation: 7%
Standard force of the hand: 50 daN
Standard application force: 560 daN
Permissible lashing force: 5000 daN

4

Guide tensioning strap (1) as shown around the rear vehicle lift swivel arm (5) and tension using the belt buckle (4)

5

Perform operation steps 3 and 4 on opposite side of vehicle.

6

Lower vehicle with lifting platform

7.1

Open both rear doors

Model 453.0

7.2

Open both doors

Model 453.3/4

8

Release the cup holder (6) and move to the front along with the connected electrical wiring harness

Model 453.3/4
except code J59 (Center armrest)

9.1

Cover left and right rear entrance area using suitable rags and route tensioning strap (7) through footwell in rear

Model 453.0

 Use tensioning strap (7) with following properties:
Maximum elongation: 7 %
Standard force of the hand: 50 daN
Standard application force: 560 daN
Permissible lashing force: 5000 daN

9.2

Cover left and right entrance area using suitable rags and route tensioning strap (7) behind the seats through the passenger compartment

Model 453.3
Model 453.4

 Use tensioning strap (7) with following properties:
Maximum elongation: 7 %
Standard force of the hand: 50 daN
Standard application force: 560 daN
Permissible lashing force: 5000 daN

10

Route or suspend tensioning strap (7) around right and left rear vehicle lift swivel arm (5)

 Depending on the version of the tensioning strap (7) used.

11

Tension tensioning strap (7) in passenger compartment using the belt buckle (8)

12

Release in the reverse order