S30.30-4503-09
Shown on MODEL 447.8 |
1 | Steering column tube module with combination switch | B37/4 | Accelerator pedal module | |
2 | Steering column tube module with CC |
Danger ! | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
| Notes on carrying out repair work in the vehicle interior | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | ||
| Remove | ||
1 | Remove steering column tube module with combination switch (1) | ||
| Remove/install steering column module | ||
The steering column tube module with combination switch (1) contains the fanfare horns and airbag clock spring contact, the steering angle sensor, the steering column tube module control unit and the switch panel. It is a single component and can only be removed completely. | |||
2 | Remove accelerator pedal module (B37/4) | ||
| Remove/install accelerator pedal | ||
The removed accelerator pedal module (B37/4) is no longer needed. | |||
| Install | ||
3 | Install new accelerator pedal module (B37/4) with a kickdown switch | ||
| Remove/install accelerator pedal | ||
4 | Install new steering column tube module with CC (2) | ||
| Remove/install steering column module | ||
The steering column tube module with CC (2) contains the fanfare horns and airbag clock spring contact, the steering angle sensor, the steering column tube module control unit and the switch panel. It is a single component and can only be replaced completely. | |||
5 | Enter special equipment via Vehicle Documentation (VeDoc) | Designation of the respective special equipment: code MS1 (CC). | |
6 | Connect diagnostic system and read out fault memory | ||
| Connect STAR DIAGNOSIS and read out fault memory | ||
7 | Perform SCN coding of electronic ignition lock control unit (EZS) (N73) | ||
| SCAN coding of control units | ||
Under the "Control unit adaptations" menu item follow the instructions for "SCN coding". | |||
8 | Perform SCN coding on the respective CDI control unit (N3/33) or CDI control unit (N3/36) | ||
| SCAN coding of control units | ||
Under the "Control unit adaptations" menu item follow the instructions for "SCN coding". | |||
9.1 | Perform SCN coding of instrument cluster (IC) control unit (A1/1) | MODEL 447.6/7 | |
| SCAN coding of control units | ||
Under the "Control unit adaptations" menu item follow the instructions for "SCN coding". | |||
9.2 | Perform SCN coding on gateway for user interface CAN (N93/4) | MODEL 447.8 | |
| SCAN coding of control units | ||
Under the "Control unit adaptations" menu item follow the instructions for "SCN coding". | |||
10 | Close off diagnostic system | ||
| Check | ||
11 | Perform function test during the test drive |
Powiązane dokumenty
- ad0000s200004e
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ah9100p000401a Przepisy prawa regulujące obchodzenie się i składowanie zespołów poduszek powietrznych i napinaczy pasów bezpieczeństwa
- ar3012s1321e
- ar5421s0015e Kodowanie SCN modułów sterujących
- ar5425s2802e
- as9100z000101a Niebezpieczeństwo obrażeń podczas czynności diagnostycznych i naprawczych przy zespołach poduszki powietrznej i napinaczy pasów bezpieczeństwa.