AR91.29-P-1421G | Removing and installing seat height adjustment drive | 19.7.99 |
MODELS 463.200 /204 /206 /207 /208 /209 /220 /221 /224 /225 /227 /228 /230 /231 /232 /233 /240 /241 /300 /304 /307 /308 /320 /321 /324 /325 /327 /328 /330 /331
with CODE (SB5) Electrically adjustable left front seat
with CODE (SB6) Electrically adjustable right front seat
P91.29-2127-11
1 Screw for seat height adjustment motor
P91.29-2128-11
2 Bracket screws
3 Bracket
4 Plastic clip
5 Plug-in wiring plug connection
6 Plug-in wiring plug connection
7 Tie strap
M18m1 Seat height motor
M19m1 Seat height motor
| Remove/Install | ||
1 | Move front seat all the way forward | ||
2 | Remove the screws securing the seat height adjustment motor (1). | Pull up the seat until access to the screws (2) and the plug-in wiring connection (5, 6) is available. | |
3 | Cut off the wire ties (7). | ||
4 | Disconnect electrical connector (5, 6) from seat height motor (M18m1, M19m1) | Mark terminals to prevent any risk of incorrect connections. | |
5 | Remove screws at bracket (2) | ||
6 | Remove bracket (3) from seat frame. | Installation: lightly grease plastic clip (4) before installation. | |
7 | Remove seat height motor (M18m1, M19m1) | ||
8 | Install in the reverse order | ||
9 | Run an operational check on front seat | See Operating Instructions |