P83.25-0274-06
1 Water collector
2 Plastic rivet
3 Main air flap
4 Smog sensor
5 Control module box
6 Wiper rubber pads
7 Wiper unit mount
8 Air intake clips
B31x1 Smog sensor connector
P83.25-0281-06
5 Control module box
9 Cover screw
10 Cover
11 Screw
12 Clamping screw
13 Engine control module
K40 Relay unit (HFM-SFI, HFM-LP, ME 1.0, EDC, basic function)
N10-1 Multi-function control module (convenience feature CF, windshield wiper, rear window defroster, box fan)
N15/1 5-speed automatic transmission control module (EATC)
N47-1 ASR/SPS control module
N47-2 ETS/SPS control module
| Removal, installation | ||
1 | Remove left air inlet | ||
2 | Remove right air inlet | ||
3 | Remove windshield wiper | ||
4 | Remove rubber pads (6) | ||
5 | Remove windshield wiper mount (7) | ||
6 | Unclip clips (8) | ||
7 | Remove plastic rivet (2) | ||
8 | Disconnect connector for smog sensor (B31x1) | Vehicles with air conditioning (automatic) (code 581) | |
9 | Disconnect ground lead on battery | Insulate terminal on ground lead to prevent unintentional contact between connected ground lead and ground point W10 | |
10 | Unscrew screws (9) and remove cover (10) | Installation: Ensure that gasket for cover is properly seated | |
11 | Remove control module N10-1 from control module box | ||
12 | Loosen clamping screw (12) | ||
13 | Unscrew screws (11) and move upper section of control module box (5) toward front | ||
14 | Remove water collector (1) | When removing and installing the water collector (1) ensure that the main air flap is not damaged | |
15 | Reinstall in opposite order |