ar7216d7844a

Remove/install sliding door bottom carriage

유형 ar · 주제 72.16 · 버전 0401 · 2011-07-13

적용 대상: MODEL 900 with CODE (T16) Right load compartment sliding door MODEL 906.6/ 7

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 3 구조 › 72 도어 › 72.16 슬라이드　도어 — 시리즈 900 · 시리즈 906 (모델 6**, 7**)

EinPAS 35 바디/프레임/부착 부품 › 35.35 도어 › 35.35.44 슬라이딩 도어 — 시리즈 900 · 시리즈 906 (모델 6**, 7**)

AR72.16-D-7844A

Remove/install sliding door bottom carriage

28.6.11

MODEL 900 with CODE (T16) Right load compartment sliding door

MODEL 906.6/ 7

Remove/install sliding door bottom carriage

D72.16-1294-09

1 Cable track

2 Sectional molding

3 Bottom carriage

6 Door catch cable

7 Control cable guide

4 Bracket

5 Cable bracket

Remove/install

Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Remove lower guide rail

AR72.16-D-7816A

2

Mark wiring harness on cable track outlet

For this purpose hold wiring harness under tension by pulling slightly and mark wiring harness length at cable track outlet with insulation tape.

Installation: Ensure that the marking is positioned at the track outlet or the length of the wiring harness between the cable track outlet and the 1st cable tie (area A) is 90 mm with short wheelbase and 205 mm for all other wheelbases. Observance of this minimum dimension prevents clicking noises from occurring when the sliding door is opened.

3

Unclip cable track (1) from section molding (2)

4

Unscrew lower carriage (3) from brackets (4)

Mark position before removal.

5

Unscrew bracket (4) from sliding door

Mark position before removal.

6

Unclip cable track (1) from lower carriage (3)

Pry cable track (1) with screwdriver over casting lug (arrow) on lower carrier (3)

Installation: Ensure that the cable is routed correctly in the lower carrier (3) Never grease cable track (1).

7

Unclip cable holder (5) and unhook door catch cable (6)

When replacing lower carriage (3), transfer control cable guide (7).

8

Install in the reverse order

9

Adjust lower carriage (3)

Model 906 without code (D03) Roof and rear-end doors, high version.

AR72.16-D-1023-01H

*BA72.16-N-1004-01A

Model 906 with code (D03) Roof and rear-end doors, high version,

Model 900

AR72.16-D-1023-01I

*BA72.16-N-1004-01A

Sliding doors

Number

Designation

Model
900

Model
906.6/7

BA72.16-N-1004-01A

Screw for bottom carriage on sliding door

Nm

23

23

참조 문서