Adjust sliding door

AR72.16-D-1023G

Adjust sliding door

27.2.12

 Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A



Check the setting of the sliding door.

1

Check height and parallelism of sliding door (3) in relation to vertical and horizontal frame profile as well as side wall

 The striker pin (2) should run into the door lock (4) in the center, the guide rollers (9) should not hit the floor of the guide rails (7) or protrude beyond the edge of guide rail (7). The seal (11) must be located in the specified groove (12).

Adjust height and inclination

2

Open and hold sliding door (3)

3

Loosen nuts (1) of support roller (10) to be adjusted with aid of helper and adjust sliding door (3).

 Ensure that the sliding door (3) does not slip out of the bracket.

 To ensure parallelism when closed, the open sliding door (3) should form a wedge-shaped gap slightly narrower at the bottom in relation to the vertical frame channel (5).

Adjust height so that striker pin (2) runs into the door lock (4) in the center, the guide rollers (9) should not hit the floor in the guide rail (7) or protrude beyond the edge of the guide rail (7). The seal (11) must be located in the specified groove (12), if necessary fit position of door lock (4). See 

Check adjustment of door lock (4) and adjust.

AR72.16-D-4035-01A

4

Tighten loosened nuts (1) with aid of helper.

5

Check parallelism in relation to vertical frame profile (5) and easy motion of sliding door (3).

 If necessary, repeat operation steps one to four.

6

Close sliding door (3)

Adjust flatness

7

Open sliding door (3)

8

Loosen nuts (8) of guide rollers (9) to be adjusted

 Counterhold on hexagon of guide roller (9).

9

Adjust sliding door (3) using three guide rollers (9)

 The sliding door (3) should run parallel and vertical to the frame profiles (5, 6)

The outer guide rollers (9) should run at the outer cheek on the center guide roller (9) at inner cheek of the guide rail (7).

10

Tighten loosen nuts (8)

 Counterhold on hexagon of guide roller (9).

Secure nuts (8).

Loctite 243

*BR00.45-Z-1133-02A

11

Check sliding door (3) for flatness and easy motion, if necessary repeat operation steps six to ten.

12

Close sliding door (3)

Number

Designation

Order number

BR00.45-Z-1133-02A

Loctite 243

A 613 989 09 71