ar4340d1600c

Remove/install Telma retarder rotor

유형 ar · 주제 43.40 · 버전 0103 · 2011-09-13

적용 대상: MODEL 906 with CODE (PB2) Mastercode retarder VMC

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 2 섀시 › 43 브레이크-공압장치 및 보조브레이크 › 43.40 리타더 (전기식) — 시리즈 906

EinPAS 21 브레이크/진공압 시스템/압축 공기 시스템 › 21.21 리타더 › 21.21.30 하우징/커버/샤프트/리타더 — 시리즈 906

AR43.40-D-1600C

Remove/install Telma retarder rotor

12.9.11

MODEL 906 with CODE (PB2) Mastercode retarder VMC

Remove/install Telma retarder rotor

D43.40-0041-09

1 Fuse

2 Screw

5 Rotor

3 Disk spring

4 Thrust washer

Remove/install

1

Lift/jack up vehicle

AR00.60-D-1000H

2

Detach corresponding drive shaft of rotor (5) to be set on retarder and fix in place using cable ties

Mark installation position of front propeller shaft relative to rear drive shaft and retarder. The universal joints of the drive shafts must not be offset to each other, but rather they must be synchronously installed.

Installation: Install new nuts.

*BA41.10-N-1013-01B

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

3

Bend up retainer (1)

Installation: Secure bolt (2) with retainer (1).

4

Remove bolt (2) and retainer (1)

Installation: Install new retainer (1).

*BA43.40-N-1008-01C

5

Remove disk spring (3) and pressure plate (4)

6

Remove rotor (5) from rotor shaft

Mark installation position of rotor (5) relative to rotor (5) on opposite side.

Installation: Observe identification of rotor (5) relative to rotor (5) on opposite side.

7

Install in the reverse order

8

Adjust gap

AR43.40-D-1400C

Propeller shaft

Number

Designation

Model
906 without code ZG1/ZG2/ZG3/
ZG4

BA41.10-N-1013-01B

Nut, drive shaft to retarder

M101

Stage 1

Nm

15

Stage 2

°

90

Retarder

Number

Designation

Model
906
with code PB2

BA43.40-N-1008-01C

Bolt, rotor to rotor shaft

M121.5

Nm

50

참조 문서