ar4030p0451d

Checking alignment of steering knuckle (removed)

유형 ar · 주제 40.30 · 버전 0104 · 2006-07-26

적용 대상: MODEL 210.081 /082 /083 /281 /282 /283

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 2 섀시 › 40 휠, 섀시 측정 › 40.30 사고측정 — 시리즈 210 (모델 081, 082, 083, 281, 282, 283)

EinPAS 17 드라이브 트레인/액슬 › 17.50 앞차축 › 17.50.42 스티어링 너클/휠 허브/휠 베어링 — 시리즈 210 (모델 081, 082, 083, 281, 282, 283)

EinPAS 20 섀시 › 20.10 섀시 얼라인먼트 › 20.10.20 진단/점검/측정/조정 — 시리즈 210 (모델 081, 082, 083, 281, 282, 283)

AR40.30-P-0451D

Checking alignment of steering knuckle (removed)

26.9.96

MODEL 210.081 /082 /083 /281 /282 /283

Checking alignment of steering knuckle (removed)
Checking alignment of steering knuckle (removed)

P40.30-0336-01

Left steering knuckle shown

P40.30-0337-01

Checking alignment of steering knuckle (removed)
Checking alignment of steering knuckle (removed)

P40.30-0339-01

P40.30-0338-01

Removal, installation

1

Remove and install steering knuckle

AR33.25-P-0400D

Measuring

2

Place steering knuckle with wheel hub or brake disc installed on parallel supports

*WH58.30-Z-1015-12A

3

Scan and note height dimension "A" as comparative dimension with a height marking device

Measure at the flat surface of the brake caliper mounting.

*WH58.30-Z-1016-12A

4

Scan and note height dimension "B1-B3" at the lowest point of the each bore.

The test values result from the difference in height dimension "A" to the height dimensions:

"B1"= Bearing of supporting joint

"B2"= Bearing of upper wishbone

"B3"= Bearing of steering knuckle arm/tie rod

*BE40.30-P-1001-01A

Test values - steering knuckle

Number

Designation

Models 210.08/28

BE40.30-P-1001-01A

Difference in height measurement

"A" – "B1"

mm

23.31

"B2" – "A"

mm

65.61

"B3" – "A"

mm

1.81

Refer to illustration

AR40.30-P-0451D

Commercially available tools

Number

Designation

WH58.30-Z-1015-12A

Parallel bases

WH58.30-Z-1016-12A

Height marking device

참조 문서