363 589 02 21 00
Dial gage holder
Dial gage
001 589 53 21 00
T35.30-0029-02
1 Attach dial indicator holder (1) with dial indicator (2) to pinion housing.
Position of pinion housing with drive pinion:
The head (with the gearing) of the drive pinion should face downwards.
2 Position preloaded feeler of dial indicator (2) in centering hole on end face of drive pinion gear shaft.
3 Set scale of dial gage to 'zero'.
4 Rotate assembly device by 180 °. The head (with the gearing) of the drive pinion should then face upwards.
5 The value shown on the dial gage is the measured end play (S1) of the drive pinion gear shaft.
6 Determine thickness of shims required:
SH_NEW (mm) = SH_OLD (mm) - S1 (mm) - 0.1 mm
SH_NEW = Thickness of new shim
SH_OLD = Thickness of old shim
S1 = Measured end play
0.1 = Preload displacement