AR33.20-P-0500-02A | Check/adjust installation position of upper transverse control arm relative to bearing shell | |
Test specifications for wheel location, wheel hub
Number | Designation | Model | ||
BE33.20-P-1001-01A | Test dimension "A" for adjusting the upper wishbone in the bearing shell | mm | 63 | |
See picture | ||||
Wheel location, hub
Number | Designation | Model | ||
BA33.20-P-1008-01A | Self-locking nut of upper wishbone in bearing shell | Nm | 120 | |
P33.20-0285-02
The bearing shell (6a) is screwed on to the upper transverse control arm (6) in a defined position (dimension A see Table. In the event of deviation, adjust the incline angle of the upper transverse control arm.
1 Loosen self-locking nut (6e).
2 Adjust incline angle of upper transverse control arm as per check dimension "A".
3 Tighten self-locking nut (6e) with specified .