AR32.35-D-2210A | Remove/install anti-roll bar on rear axle | 14.10.09 |
MODEL 901, 902, 903
MODEL WD1, WD2, WD3, WD6, WD7, XD1, XD2, XD3, XD6, XD7, YD1, YD2, YD3, YD6, YD7
MODEL 690.611 /63 /64
D32.35-0028-06
1 Nut M12x1.5
2 Rubber bushing
3 Link rod
4 Bolt M12x1.5
5 Stabilizer
6 Bolt M8
7 Bracket
8 Square nut M8
9 Nut M8
10 Washer
11 Bolt M8
12 Clip
13 Rubber bushing
| Remove | ||
1 | Detach link rods (3) from longitudinal frame member | ||
2 | Unscrew fixing of clamp (12) on axle tube | Unscrew nuts (9) and remove bolts (6) | |
3 | Remove stabilizer bar (5) with clamps | ||
4 | Detach link rods (3) from stabilizer bar (5) | Check rubber mount and replace if necessary | |
Remove rubber mount from link rod and rear axle stabilizer bar | |||
| |||
| Install | ||
5 | Mount link rods (3) on stabilizer bar (5) | Only fit on screwed connection, do not tighten. | |
6 | Engage stabilizer bar | ||
7 | Mount link rods (3) on longitudinal frame member | Only fit on screwed connection, do not tighten. | |
8 | Attach stabilizer bar (5) to axle tube with clamp (12) | Only fit bolts (6) with washers (10) and nuts (9), do not tighten. | |
9 | Center stabilizer (5) | ||
10 | Tighten threaded connection of link rods (3) on longitudinal frame member and stabilizer bar | | |
11 | Tighten threaded connection of clamp (12) and fixing on axle tube | | |
|
Anti-roll bar
Number | Designation | Model 690.611/63/64, | Models | ||
BA32.35-N-1001-03B | Screw, connecting rod to stabilizer and longitudinal frame member (rear axle) | M121.5 | Nm | 95 | 95 |
BA32.35-N-1002-03B | Screw, stabilizer clamp to rear axle tube | M8 | Nm | 25 | 25 |
M10 10.9 | Nm | - | - | ||
M121.5 | Nm | - | - | ||
BA32.35-N-1003-03B | Threaded connection of stabilizer bar clamp (rear axle) | M8 | Nm | 25 | 25 |
601 589 04 43 00
Installation tool