S26.10-4517-09
Shown with CODE E07 (Start-off assist) |
1 | Bracket | 3 | Electrical connector | 5 | Transmission | ||
2 | Shift cable | 4 | Hydraulic line | W11/1 | Engine ground point |
Shown with CODE JD1 (Tachograph with digital technology) |
B6/34 | Manual transmission speed Hall sensor |
S26.10-4516-01
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Topical note | Brake fluid notes | ||
Topical note | Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Remove ground line from battery | ||
2 | Remove lower engine cover | ||
3 | Remove holder (1) | Nut/bolt, bracket to front exhaust system | |
Screw/bolt, manual transmission to engine | |||
4 | Remove engine cross member at rear |
| |
5 | Unclip shift cables (2) from gearshift linkage | ||
6 | Detach drive shaft with flexible coupling from transmission (5) | ||
Bolt, drive shaft to flexible coupling on transmission | |||
Bolt, propeller shaft center support bearing to underfloor | |||
Bolt, flexible coupling to transmission | |||
7 | Detach engine ground point (W11/1) | Screw/bolt, manual transmission to engine | |
8 | Detach manual transmission speed Hall sensor (B6/34) | MODEL 447 with CODE JD1 (Tachograph with digital technology) | |
Bolt, speed sensor for tachograph to transmission | |||
9 | Disconnect electrical connector (3) | MODEL 447 with CODE E07 (Start-off assist) | |
10 | Detach hydraulic line (4) | To do so, remove safety clip. Seal the connections and collect the discharged brake fluid. | |
Record plug | |||
11 | Support and secure transmission (5) | ||
| 000 588 11 62 00 Major assembly mount | ||
| 000 588 10 62 00 Support plate | ||
12 | Remove remaining screws of transmission (5) from engine | ||
Topical note | Notes on using electrical or pneumatic screwdrivers/impact wrenches | ||
Screw/bolt, manual transmission to engine | |||
13 | Remove transmission (5) by moving toward rear and lowering | Installation: Apply light coating of grease to main shaft. | |
Long-life grease | |||
| Check | ||
14 | Perform visual inspection of central clutch release bearing, grooved ball bearing and flywheel | ||
15 | Install in the reverse order | ||
| Check | ||
16 | Check oil level; correct as required | ||
| Gear oils (Sheet 235.10) | ||
Filling screw to transmission housing | |||
17 | Bleed clutch operating system | ||
18 | Perform a function check on clutch | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
19 | Check for leak tightness with engine running | Visual inspection only. |
129 589 00 91 00
Record plug
참조 문서
- ah0000n000101a 자가 잠금식 볼트와 너트 관련 지침
- ah0000n001701a 전동식 또는 공압식 자동 드라이버 사용 관련 지침
- ah4250p000101a 브레이크액 관련 지침
- ar2210s1170e
- ar2520s0070e
- ar4110s005014e
- ar5410s0003e
- ar5410s0003e
- ar6120s1105e
- ar6120s1105e
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as0000z001001a 리프터에서 차량이 미끄러지거나 틸팅 시 생명의 위험
- as4250z000101a 브레이크액 음용으로 인한 중독 위험, 브레이크액이 피부 또는 눈에 닿아 발생하는 상해 위험
- bb0040p023510a 변속기 오일(사양 235.10)
- ws0100p0092b
- ws2600p3309b