P20.20-2013-09
1 Viscous fan
2 Fan shroud
3 Cover
4 Coolant line radiatorthermostat housing
5 Coolant line radiatorcoolant pump
6 Coolant line expansion reservoirradiator
7 Coolant line expansion reservoirradiator
8 ATF line
9 ATF line
10 Bracket ATF line
11 Radiator
12 Clips
13 Radiator crossmember
14 Bracket supercharger line
15 Supercharger line
| Remove/install | ||
1 | Remove engine compartment paneling | ||
Danger! | Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. | |
2 | Drain coolant at radiator, pour in | ||
3 | Remove viscous fan (1) | Right-hand thread! | |
4 | Remove fan shroud (2). | - On vehicles with suction fan, first disconnect connector for suction fan. | |
5 | Remove cover (3) | ||
6 | Detach coolant line (4, 5) | ||
7 | Detach coolant line (6, 7) | ||
8 | Remove ATF lines (8, 9) | Seal connections! | |
| |||
| |||
| |||
9 | Remove bracket (10) of ATF line (8) at radiator (11) | ||
10 | Remove clamps (12) | ||
11 | Remove radiator crossmember (13) | ||
12 | Remove bracket (14) from supercharger line (15) | ||
13 | Unbolt condenser at radiator | Big 3 bolts on upper radiator. | |
14 | Unhinge capacitor | Installation: Capacitor must be seated in the two retainers (arrow) of the radiator (11). | |
15 | Remove radiator (11) | Installation: The studs on the radiator must be located at the bottom in the rubber mounts on the crossmember. | |
16 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
17 | Check oil level in automatic transmission, correct if necessary | ||
18 | Inspecting cooling system for leaks |
Radiator, coolant hoses
Number | Designation | Engine | Engine 113.987/ | ||
BA20.20-P-1001-01A | Union nut, automatic transmission oil line to radiator | Nm | 20 | 18 | |
BA20.20-P-1003-01A | Banjo bolt | M121.5 | Nm | 30 | 30 |
Set of stop plugs
129 589 00 91 00
참조 문서
- ar2000p1010ha 냉각 시스템 기밀성 점검
- ar2000p1010ha
- ar2000p1142ha
- ar2000p1142ha 냉각수 배출, 주입
- ar2040p5660c
- ar2700p0100ac 자동 변속기의 오일 레벨 점검, 필요한 경우 적절히 조절
- ar6120p1105ab
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as2000z000101a 뜨거운 냉각수 분출 시 입은 화상에 의한 피부와 안구의 상해 위험 냉각수의 음용으로 인한 중독 위험