Remove/install oil filter housing

AR18.20-P-3471VA

Remove/install oil filter housing

20.7.09

21.7.04

Remove oil filter element from oil filter housing - added

Step 6

 

Remove/install

Danger!

Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.

Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.

Wear protective gloves, protective clothing and safety glasses.

AS20.00-Z-0001-01A

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle with vehicle lift

AR00.60-P-1000V

2

Remove the front and central sections of the lower engine compartment paneling

AR61.20-P-1105V

3

Drain coolant at radiator

AR20.00-P-1142VA

4

Open engine hood and raise to vertical position

AR88.40-P-1000V

5

Remove left engine intake air duct and front engine cover

See "Remove/install air filter housing".

AR09.10-P-1150VA

6

Remove oil filter element from oil filter housing (7)

 To empty the oil filter housing (7).



Replace oil filter element, drain oil filter

AP18.00-P-0101-06V



*BA18.20-P-1001-01O



*103589020900

7

Detach the top coolant hose (1) from the coolant thermostat housing (2) and the radiator (3) and set aside

 Installation: Replace O-rings.

8

Remove fan shroud (4)

AR20.40-P-6800VA

9

Remove poly-V belt

AR13.22-P-1202VA

10

Remove poly-V-belt tensioning device (5)

AR13.25-P-3200VA

11

Remove the guide pulley (6) of the poly-V-belt



*BA20.10-P-1004-01U

12

Remove coolant thermostat housing (2)



*BA20.10-P-1003-01U

13

Remove bolts (7a)

 Installation: Observe bolt order and tightening torques:



Bolt plan for oil filter housing

AR18.20-P-3471-01VA



*BA18.20-P-1002-01O



*BA18.20-P-1003-01O

14

Remove oil filter housing (7)

15

Replace seal (7b)

16

Install in the reverse order



Checking

17

Check engine oil level, correct if necessary.

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

18

Conduct engine test run and check engine for leaks

Number

Designation

Engine 272

BA18.20-P-1001-01O

Threaded cap to oil filter housing

Nm

25

BA18.20-P-1002-01O

Self-tapping screw, oil filter housing to timing case cover

Nm

20

BA18.20-P-1003-01O

Bolt, oil filter housing to crankcase

Nm

20

Number

Designation

Engine 272

BA20.10-P-1003-01U

Bolt, coolant thermostat housing to timing case cover

Nm

25

BA20.10-P-1004-01U

Bolt, guide pulley between water pump and belt tensioner

Initial installation

Nm

35

Follow-up operations

Nm

25