W07.15-0085-12
1 Engine trim panel
2 Injection line
Modification notes
26.4.01 | Value changed from 25 Nm to 35 Nm | Figure in BA07.15-N-1004-01A for engine 904.9, 906.9 modified |
| Removing | ||
Danger! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel | No fire, sparks, open flames or smoking. Wear protective clothing when handling fuel. | |
1 | Remove engine panel (1) | ||
2 | Remove injection line (2) | Injection lines (2) must not be bent. | |
| |||
| |||
| Install | ||
3 | Install injection lines (2) | The injection lines (2) must not be bent and the installation position is to be observed. | |
| |||
| |||
| |||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
4 | Bleed fuel system | To do this allow engine to run for about a minute and then stop it. The fuel system purges itself automatically while the engine runs. Crank engine with starter for maximum 90 seconds. Possibly wait at least for about 2 minutes before repeating attempt at starting. | |
5 | Check injection lines (2) for leaks by means of a visual inspection | In cases of leaks replace the injection lines (2) involved. | |
6 | Install engine panel (1) |
Diesel injection system with unit pumps (MR/PLD)
Number | Designation | Engine Engine | ||
BA07.15-N-1004-01A | Injection line to pressure pipe connection and unit pump | Nm | 35 | |
000 589 68 03 00
Box wrench bit
Ring wrench
000 589 07 03 00
참조 문서
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as4700z000101a 인화에 의한 폭발 위험, 연료의 흡입 및 음용에 의한 중독 위험, 연료의 피부 및 안구 접촉에 의한 상해 위험