S07.08-4537-78
1 | Diesel injection system control unit | 5 | Bracket | |
2 | Electrical connector | 6 | Air duct segment | |
3 | Electrical connector | 7 | Nuts | |
4 | Retaining clips |
1 | Diesel injection system control unit |
6 | Air duct segment |
8 | Bolts |
S07.08-4538-75
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Connect vehicle diagnosis system and carry out initial startup of the diesel injection system control unit (1). | If the diesel injection system control unit (1) is replaced. | |
Notes on programming control units | |||
| |||
2 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
3 | Remove upper engine cover. | ||
4 | Remove retaining clamps (4) with attached engine wiring harness and vehicle wiring harness from bracket (5). | ||
5 | Release and disconnect electrical connector (2). | ||
6 | Release and disconnect electrical connection (3). | ||
7 | Pull air duct segment (6) with attached diesel injection system control unit (1) out of the elastomer bearing and remove. | Installation: Pay attention to the correct seating of the air duct segment (6) in the elastomer bearing. | |
8 | Unscrew nuts (7) and remove bracket (5). | If the diesel injection system control unit (1) is replaced. | |
9 | Remove bolts (8). | If the diesel injection system control unit (1) is replaced. | |
10 | Remove diesel injection system control unit (1) from air duct segment (6). | If the diesel injection system control unit (1) is replaced. | |
11 | Install in the reverse order. | ||
| Check | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
12 | Perform an engine test run and check the engine for proper function. |
참조 문서
- ad0000s200006p
- ah5400p000101a 정전기 방전으로 인한 전자 부품 손상 방지 지침
- ah5421p000103z 컨트롤 유닛 프로그래밍 지침
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험