ar0520p6010rx

Checking basic position of camshafts

유형 ar · 주제 05.20 · 버전 0100 · 2006-01-24

적용 대상: ENGINE 272, 273 in MODEL 230 Basic position of camshaft for an installed front cover on cylinder head at a 55° crank angle BTDC'

“ko”(으)로는 제공되지 않아 영어(으)로 표시합니다.

위치

기능 그룹 1 엔진 › 05 엔진제어장치 › 05.20 캠샤프트, 캠샤프트 조절장치 — 시리즈 230

EinPAS 15 엔진 › 15.17 엔진 컨트롤 › 15.17.30 밸브 드라이브 — 시리즈 230

엔진/변속기에도 적용: 272 ***, 273 ***

AR05.20-P-6010RX

Checking basic position of camshafts

10.1.06

ENGINE 272, 273 in MODEL 230
Basic position of camshaft for an installed front cover on cylinder head at a 55° crank angle BTDC

Checking basic position of camshafts

P05.20-2163-06

1 Marking on belt pulley

2 Guide edge on timing case cover

3 Markings on pulse wheels

Remove/install

1

Remove air filter housing

AR09.10-P-1150RX

2

Remove Hall sensor on camshafts

AR15.10-P-2000RX

Checking

3

Turn engine at the crankshaft in the direction of rotation of the engine (arrow) to a 55°Crank before ignition TDC (305° marking on the belt pulley) and check the basic position of the camshafts

The 305° marking on the belt pulley (1) must be aligned with guide edge (2) on timing case cover and markings (3) on the pulse wheel (2) must be located in the middle in the sensor holes (Hall sensor). Adjust basic position of camshafts if necessary:

Set the basic position of camshafts.

AR05.20-P-6020RX

4

Install in the reverse order

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

5

Carry out an engine test run and check the engine for leaks

참조 문서