Removing and installing flywheel / driven plate

AR03.30-D-8001C

14.2.96

ENGINE 111.979 in MODEL 901, 902, 903, 904

D03.30-1003-09

1 Flywheel

2 Torx bolt

3 Straight pin

4 Driven plate (of automatic transmission)

5 Plate (of automatic transmission)

6  Retaining lock

 	Removing, installing
1.1	Remove manual transmission		AR26.10-D-0020B
1.2	Remove automatic transmission	 On models with automatic transmission	AR27.10-D-0500C
2	Remove clutch		AR25.10-D-0050A
3	Install lock (6) for crankshaft/starter ring gear		AR03.30-D-5000C
4	Unscrew tox bolts (2)		*BA03.30-N-1002-01A
			*000589011000
		 Installing: replace torx bolts (2). If no torquing angle wrench is available, the torx bolts (2) can be torqued further in a single operation by the specified angle using a wrench and tommy bar
5	On manual transmission, take off flywheel (1) or on automatic transmission, take off driven plate (4) and plates (5)	 The straight pin (3) centers the flywheel (1) or driven plate (4), respectively.  Installing: new flywheel can be installed without static or dynamic balancing.
6	Install in the reverse order

 Flywheel, driven plate, vibration damper, starter ring gear

Number	Designation			Engine 111.979/ 984


BA03.30-N-1002-01A	Flywheel/driven plate to crankshaft	1.pitch	Nm	50
		2.pitch	°	90

000 589 01 10 00

Torx bit set