Crankshaft
Number | Designation | Engine | |||
BA03.20-N-1001-01L | Bolt for crankshaft bearing cap | M8 | Stage 1 | Nm | 20 |
Stage 2 | ° | 90 | |||
M10 | Stage 1 | Nm | 5 | ||
Stage 2 | Nm | 30 | |||
Stage 3 | ° | 90 | |||
BA03.20-N-1002-01L | Side bolt for crankshaft bearing cap | M8 | Nm | 30 | |
D03.20-1121-06
Tighten the crankshaft fitted bearing cap (A) and the crankshaft bearing caps (B, C, D) individually in alphabetical order. The arrow identifies direction of travel.
To rule out angular errors, do not use a bending rod torque wrench for the final tightening.
If no angle tightener is available for the final tightening, tighten bolts (1 to 6) further in a single operation using a socket wrench and a toggle. The bolts (1 to 6) are tightened in the sequence specified below.
1 Oil the thread and the bolt head contact surfaces of the bolts (1 to 6) with engine oil.
P03.20-2153-03
2 Tighten bolts (1, 2) (M10) to stage 1.
3 Tighten bolts (3, 4) (M8) to stage 1.
4 Tighten bolts (5) (M8).
5 Tighten bolts (6) (M8).
6 Tighten bolts (1, 2) (M10) to stage 2.
7 Tighten bolts (3, 4) (M8) to stage 2.
8 Tighten bolts (1, 2) (M10) to stage 3.