N07.57-0226-01
1 Threaded cap
2 Sealing ring
3 Filter element
4 Dirt collecting tank
5 Fuel filter housing
N07.57-0225-01
| Removing | ||
Danger! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel | No fire, sparks, open flames or smoking. Wear protective clothing when handling fuel. | |
1 | Unscrew cap on fuel tank | So that the fuel can flow back into the fuel tank when the threaded cap (1) is unscrewed from the fuel filter housing (5). | |
2 | Detach transverse switch tube | Only on right-hand drive vehicle | |
| |||
3 | Unscrew the threaded cap (1) | Only remove the threaded cap (1) with the filter element (3) installed, after the fuel has run out of the fuel filter housing (5). | |
4 | Remove the threaded cap (1) together with the filter element (3) installed | ||
5 | Unclip filter element (3) by pressing out the threaded cap (1) sideways | ||
6 | Pull the dirt collecting container (4) out of the | Ensure that the dirt deposited does not enter the fuel filter housing (5). Do not wipe out the fuel filter housing (5) under any circumstances. | |
7 | Clean threaded cap (1) and dirt-collecting vessel (4) | ||
| Install | ||
8 | Replace seal (2) | Grease seal slightly. | |
9 | Insert new filter element (3) into the screw cap (1) | ||
10 | Insert the dirt-collecting vessel (4) in the fuel filter housing (5) | Install components in correct positions. | |
11 | Screw on the threaded cap (1) together with filter element (3) and tighten | | |
12 | Fit on transverse shift tube | Only on right-hand drive vehicle | |
| |||
13 | Screw cap onto fuel tank | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
14 | Bleed fuel system | Allow engine to run to do this for at least one minute. The fuel system is bled automatically. | |
15 | When the engine is running check whether fuel escapes from the threaded cap (1), eliminate cause if necessary | ||
16 | Turn off engine |
Shift mechanism
Number | Designation | Model 684 Right-hand drive with transmission 712.353 | |
BA26.60-N-1001-01L | Bolt securing support of transverse shift tube to engine | Nm | 40 |
Fuel filter
참조 문서
- ap2660i010001b
- as0000z000501a 엔진이 작동 중인 상태에서 급발진에 의한 사고 위험 시동 또는 구동 중인 엔진 근처에서 작업할 때 차량에 부딪히거나 열에 의한 상해 위험
- as4700z000101a 인화에 의한 폭발 위험, 연료의 흡입 및 음용에 의한 중독 위험, 연료의 피부 및 안구 접촉에 의한 상해 위험