W46.25-0031-11
1 Limit screw LL - right stop (marked with "R")
2 Limit ScrewLL - left stop (marked with "L")
3 Oil tank
4 Oil level dipstick
Bleed | |||
Danger! | Risk of injury by imprisonment and crushing while tilting the cabin | During the cabin tilting any person shall not be inside the tilting area. Always tilt the cabin up to the final position and lock it. | |
1 | Tilt the cabin | ||
| Indications on cabin tilting | ||
2 | Lift the vehicle by the front axle and block with safety bracket | ||
Danger! | Risk of injury in skin or eyes by hydraulic fluid sneezed under high pressure. Risk of intoxication by ingestion of hydraulic fluid. | Before starting works in the hydraulic system, depressurize the system. Use protective clothes and glasses. | |
3 | Check the oil level of the steering gear housing with the oil level dipstick (4). If it is necessary, fill in the oil tank level (3) with hydraulic fluid | Note the prescriptions of auxiliary materials. During the bleed, oil level of the steering gear housing shall not be below the minimum level mark, otherwise the air is drawn again. | |
Danger! | Risk of accident due to unintentional movement with the engine running. Risk of injury due to crushing and burning in contact during the starting procedure or with motor while running | Block the vehicle to prevent unintentional movements. Wear tight fitting and closed work clothes. Do not touch hot or rotating parts. | |
4 | Start the motor and leave it running in idle speed | ||
Danger! | Risk of injury in skin or eyes by hydraulic fluid sneezed by high pressure. Risk of intoxication by ingestion of hydraulic fluid | Before the commencement of works in hydraulic system, depressurize the system. Use protective clothes and glasses. | |
5 | Check the level oil of steering, correct if necessary | Note the prescriptions of auxiliary materials. | |
6 | Loosen the locknut of limit screw (1) | ||
7 | Fully tighten the limit screw (1) in the centralization of the steering and tighten the locknut | Thus, the locknut needs to the in contact with the limit screw head (1) and with the steering wheel housing. | |
| |||
8 | Bleed the steering system | Hold the steering against the left stop during approx. 5 seconds, next, rotate the steering several times up to the mechanical stop. | |
The steering system automatically bleeds the air. Leave the motor running until there is no more air bubbles in the oil tank (3). | |||
Danger! | Risk of injury in skin or eyes by hydraulic fluid sneezed by high pressure. Risk of intoxication by ingestion of hydraulic fluid | Before the commencement of works in hydraulic system, depressurize the system. Use protective clothes and glasses. | |
9 | Check the level of hydraulic fluid with the oil level dipstick (4). If it is necessary, fill in the oil tank level (3) with hydraulic fluid | Note the prescriptions of auxiliary materials. | |
10 | Check and adjust the hydraulic course limit | ||
11 | Lower the vehicle by front axle | ||
Danger! | Risk of injury by imprisonment and crushing while tilting the cabin | During the cabin tilting any person shall not be inside the tilting area. Always tilt the cabin up to the final position and lock it. | |
12 | Return the cabin to its position | ||
| Indications on cabin tilting | ||
13 | Execute the test course | Check the general behavior of vehicle steering. |
Steering gear