B26.40-0034-01
1 Remove the fork (66) nut of the universal joint of the secondary shaft, utilizing an adequate device to secure it.
B26.40-0035-01
2 Remove the fork of the universal joint. Measure the axial clearances of the secondary shaft and of the intermediate shaft.
B26.40-0007-01
3 Remove the bolts (59) from the springs retaining plate (58).
B26.40-0008-01
4 Remove the retaining plate (58).
B26.40-0009-01
5 Remove the shifting springs (57).
B26.40-0010-01
6 Remove the locking balls from the bars (56).
Do not utilize a magnet to remove the balls to avoid magnetizing them.
B26.40-0011-01
7 Remove the bolt fastening the reverse gear intermediate gear shaft (89) - front housing side.
B26.40-0012-01
8 Remove the bolts fastening the input shaft bearing (40).
B26.40-0013-01
9 Utilize a rubber or plastic head hammer to detach the liquid gasket of the flange from the bearing seal of the input shaft retaining cover (42).
B26.40-0014-01
10 Remove the input shaft bearing seal (42 to 45) together with the axial clearance adjusting shims of the main shaft (46 to 51).
B26.40-0029-01
11 Remove the fastening bolts (88) and the cover of the front bearing of the countershaft (87).
B26.40-0015-01
12 Remove the axial clearance adjusting shims of the countershaft (80 to 85).
B26.40-0016-01
13 Remove the housing (62) fastening bolts, leaving two bolts, one beside each guide-pin.
B26.40-0017-01
14 Turn the transmission, so to position the rear housing downward and remove the two remaining bolts fastening the housing (62).
B26.40-0018-01
15 Detach the front housing (77) from the rear housing (74), utilizing two screwdrivers to break the sealing compound bead.
B26.40-0019-01
16 Remove the front housing (77), pulling it up.