AP82.10-B-8260E | Check and correct the adjustment of the headlamps | 12.02.16 |
Vehicle 384.0## #B, 384.0## #D, 384.1## #B, 384.1## #D, 386.0## #B, 386.0## #D, 386.3## #B, 386.3## #D, 388.0## #B, 388.0## #D, 388.3## #B, 388.3## #D
Vehicle 660.0## #B, 660.0## #D, 682.### #B, 682.### #D, 688.1## #B, 688.1## #D, 693.0## #B, 693.0## #D, 693.1## #B, 693.1## #D, 693.3## #B, 693.3## #D, 694.0## #B, 694.0## #D, 695.0## #B, 695.0## #D, 695.3## #B, 695.3## #D
B82.10-0006-01
B82.10-0011-01
B82.10-0033-01
Model 693, 694, 695
Lighting switch
Model 384, 386, 388, 660, 682, 688
Lighting switch
Combined switch
Main headlights' low beam - central position of the combined switch
Arrow: Main headlights' high beam
B82.10-0008-01
B82.10-0009-01
Low beam
High beam
B82.10-0012-01
B82.10-0001-01
Model 384, 386, 388, 660, 682, 688
3 - Fog light switch
Position I - ON
Fog light
| Check | ||
1 | Check the tires pressure and if necessary, correct it | Tires inflation pressure table. | |
693, 694, 695, 696, 958, 979.0 | |||
368, 382, 384, 634, 688 | |||
2 | Drive the vehicle on a flat surface | The headlights alignment must be carried out with the vehicle unloaded, on a flat surface and with the tires pressure correctly adjusted | |
Alignment with optical alignment device | |||
3 | Place the aligning device in front of the headlight to be aligned and position it in accordance with the equipment manufacturer's instructions | ||
4 | Turn the headlights to the low beam position, the lighting switch (1) to the II position and the combined switch to the central position | The switching of the main headlights low and high beams is done by the combined switch, located at the steering column. | |
The clear-dark limit, to the left of the central point, must be located on the horizontal line; and to the right of the central point it must deviate upwards. | |||
If necessary, actuate the regulating bolts of the headlights to correct the alignment. | |||
5 | Turn on the high beam, lighting switch (1) to the position II and the combined switch to the forward position (arrow) | The center of the light beam must reach the central point (A) inside the limit frame. | |
In the case of headlights with two filaments bulbs (low and high beam), after the low beam adjustment, the high beam is automatically aligned, consequently, just check. If the alignment of the high beam is found to be excessively incorrect, replace the headlight bulb. Small divergences of the high beams are admissible. | |||
In the case of bulbs of only one filament (high beam), correct, if necessary, the alignment of the headlight by the regulating bolts. | |||
Alignment of the fog lights | |||
6 | Place the aligning device in front of the headlight to be aligned and position it in accordance with the equipment manufacturer's instructions | Adjust the fog light alignment in such a way that the clear/dark limit is located in the horizontal separation line. |