Check and correct the adjustment of the headlamps · ap8210b8260b · Mercedes-Benz WIS

AP82.10-B-8260B

Check and correct the adjustment of the headlamps

12.02.16

Vehicle 695 with Cumbustion engine 475.979

Vehicle 696 with Cumbustion engine 457.931, 457.923, 457.924, 475.931

Check and correct the adjustment of the headlamps

B82.10-0006-01

B82.10-0033-01

1 Lighting switch
Position II - Main headlights

Combined switch

Arrow Main headlights high beam

2 Main headlights low beam (center position of the combined switch)

B82.10-0008-01

B82.10-0009-01

B82.10-0010-01

B82.10-0001-01

1 Fog light switch
Position 0 - Off
Position I - On

	Check
	Headlights aiming is to be carried out with the vehicle unladen, on a flat location and with the tires calibrated	Tire inflation pressure table.	AP40.15-B-4060B
	Aiming with optical aiming instrument
1	Place the aiming instrument in front of the headlight to be aimed and position it following the equipment maker's instructions
2	Switch-on the headlights in low beam operating the lighting switch (1) in position II	The low and high beam headlights switching is done through the combined switch, arranged at the steering column.
		The bright-dark limit, at left of the center point, has to be located on the horizontal line; and at right of the center point it has to be deviated upwards.
		If necessary actuate on the headlight setting screws to correct the aiming.
3	Switch-on the high beam. The center of the light beam has to fall on the center point (A) within the limit frame	On headlights with two filaments (low beam and high beam), after the aiming of the low beam, the high beam adjustment will have to be automatically aimed, only check. If the high beam aiming is presented excessively incorrect, replace the headlight light-bulb. Small high beam discrepancies are permissible.
		On headlights with single filament (high beam), correct if necessary, the headlight aiming actuating on the setting screws
	Aiming of fog lights
4	Place the aiming instrument in front of the headlight to be aimed and position it following the equipment maker's instructions	Adjust the fog light aiming so that the bright-dark limit is located on the horizontal separation line.

Documenti citati

ap4015b4060b