1 | Thrust screw |
2 | Locknut |
3 | Sliding pad |
A | Play between the ring gear and the thrust bolt |
B35.31-0049-01
B35.00-0007-01
1 | Thrust screw |
2 | Locknut |
3 | Sliding pad |
B35.30-0072-01
B35.30-0073-01
1 | Loose counter nut (2) | ||
2 | Screw the thrust screw (1) until the sliding pad (3) touches the crown's edge | In this operation, hold the cotter nut (2). | |
The back of the sliding insert in the ring gear is clearly distinguishable by increasing resistance to rotate thrust screw (1). | |||
3 | Adjust the play unscrewing the thrust screw (1) | | |
The thrust screw with internal hexagon has a rectangular sliding pad. | |||
Rear axles 741.91, 742.80, 743.0/1/2/3/4 745.0 (except 745.09) 5/9, 746.5/86/87, 746.890/891Clearance between the thrust bolt and ring gear - return of the thrust bolt | |||
4 | Tighten the lock-nut (2), locking the thrust bolt against the rear axle housing. | Ensure that the thrust screw (1) does not move out of the previously adjusted position. | |
If the sliding pad (3) touches the crown and the thrust screw (1) continues to move forward | |||
| |||
There is clearance in the bearings of the satellite box, and proper adjustment is required. |
Differential. ring ear and pinion check values |
Number | Designation | Rear axles 743.0, 743.1, 743.2, 743.3 | 743.4 Rear axles | ||
BE35.31-B-1004-03C | Clearance between the thrust bolt and ring gear - return of the thrust bolt | mm | - | - | |
with threat pitch of 1.5 mm | Volta | 1/6 | 1/6 | ||
with threat pitch of 2 mm | Volta | 1/8 | 1/8 |
Differential. ring ear and pinion check values |
Number | Designation | Rear axles 742.80, 745.5, 745.9, 746.5, 746.86, 746.87, 746.880, 746.97 | Rear axles 741.91/93/95, 746.991/994, 746.995/997 | ||
BE35.31-B-1004-03C | Clearance between the thrust bolt and ring gear - return of the thrust bolt | mm | - | - | |
with threat pitch of 1.5 mm | Volta | 1/6 | 1/6 | ||
with threat pitch of 2 mm | Volta | 1/8 | 1/8 |