AP00.20-B-0020B | Lubrication points | 12.02.16 |
Vehicle 693 with Cumbustion engine 457.920, 457.928, 457.919
Vehicle 695 with Cumbustion engine 475.979, 457.911, 457.914, 476.971
Vehicle 696 with Cumbustion engine 457.931, 457.923, 457.924, 475.931
B33.25-0009-02
Shaft ends
B33.25-0007-01
B33.25-0008-01
Leaf springs grease fittings
Chassis 386.0/3,
388.0/3,
660.0,
695.034/051/052,
696.080/090/365/367/369
Front axle
B33.25-0006-01
Rear axle
B83.00-0002-01
Cabin front suspension stabilizer bar sliding mounting
Right and left sides
Vehicles 693.154,/193/194/196/197
B31.10-0003-01
Fifth wheel - LS and S vehicles only
B32.00-0001-01
Rocker arm - 1938S/6X2, 1944S/6x2
Chassis 693.194/193
B41.10-0016-01
B41.10-0015-01
B41.10-0014-01
Universal joint with lubrication system
Gearbox
Intermediary bearing
Rear axle
| For lubrication using grease fittings, use only high pressure lubrication pumps which do not exceed 10 to 15 bar. | ||
1 | Clean grease fittings using cloth | ||
2 | Lubricate lubrication points | To ensure a good shaft end lubrication it is recommended to lift vehicle using front axle. | |
If required, turn transmission shaft so the lubrication pump can correctly adapt to grease fittings. | |||
A lubrication point is considered well lubricated when new grease is shown at its contour. | |||
Clean exceeding grease |