P60.10-2167-09
Set up of straightening tool and multi-Z-elements (front)
1 Locating stop for left front longitudinal member
2 Locating stop for right front longitudinal member
3 Left front engine support mount
4 Right front engine support mount
5 Insert for front engine support mount
6 Right front spring tower mount
7 Left front spring tower mount
8 Locating pin for front spring tower mounts
9 Left upper transverse control arm bearing mount
10 Right upper transverse control arm bearing mount
11 Locating pin for checking of upper transverse control arm
12 Locating pin for checking of upper transverse control arm
13 Left rear engine support mount
14 Right rear engine support mount
15 Centering pieces for rear engine mount
16 Engine support check pin
18 Carrier for right front longitudinal member frame mount
19 Carrier for left front longitudinal member frame mount
20 Longitudinal member frame mounts
21 Left transmission crossmember mount
22 Right transmission crossmember mount
23 Centering pieces for transmission crossmember
P60.10-2167-09
Set up of straightening tool and multi-Z-elements (rear)
20 Longitudinal member frame mounts
25 Center check bore mount
26 Center check bore check pin
27 Locating mount for propeller shaft bearing
28 Carrier for right rear longitudinal member frame mount
29 Carrier for left rear longitudinal member frame mount
30 Right front rear axle carrier mount
31 Left front rear axle carrier mount
32 Right rear spring tower mount
33 Left rear spring tower mount
34 Check pin for rear spring tower mounts
35 Left rear axle carrier mount
36 Right rear axle carrier mount
38 Locating stop for right rear longitudinal member
39 Locating stop for left rear longitudinal member
40 Plates for removing end panel
42 Locating stop for right upper end panel
43 Locating stop for left upper end panel
44 Plates
45 Plates for propeller shaft bearing control
1 Install multi-Z elements and straightening bracket set.
Number and position of MZ elements and straightening tools are given in the associated Celette setup plan.
Multi-Z elements:
When installing multi-Z elements on straightening bench, observe direction of arrow on multi-Z elements
The parts numbers of the multi-Z elements are cast in at side
Straightening tool:
Arrows for straightening tool always toward direction of travel
In addition to the straightening tool number, the straightening tool for the left side have the letter "L" next to the arrow
The position number in combination with the 8-digit reference number (e.g.7169.7001) is also the order number if replacement parts are required
Always setup the right side of the straightening bench analog to the left side.