ar5461d0008a

Remove/install digital tachograph (DTCO)

Tyyppi ar · aihe 54.61 · versio 0101 · 2010-11-05

Koskee: MODEL 901.6, 902.6, 903.6, 904.6, 905.6, 906 with CODE (JD1) EU digital tachograph MODEL 901.6, 902.6, 903.6, 904.6, 905.6, 906 with CODE (JD2) EU digital tachograph with rpm and additional recorder

Ei saatavilla kielellä ”fi”; näytetään kielellä Englanti.

Sijainti

Toimintoryhmä 2 Alusta › 54 Sähkölaitteet, sähkövarusteet ja mittarit › 54.61 Ajopiirturi, taksamittari — Mallisarja 901 (mallit 6**) · Mallisarja 902 (mallit 6**) · Mallisarja 903 (mallit 6**) · Mallisarja 904 (mallit 6**) · Mallisarja 905 (mallit 6**) · Mallisarja 906

EinPAS 31 Kommunikaatio/informaatio/viihdekeskus › 31.35 Ajopiirturi/tietullipääte › 31.35.40 Ajopiirturi — Mallisarja 901 (mallit 6**) · Mallisarja 902 (mallit 6**) · Mallisarja 903 (mallit 6**) · Mallisarja 904 (mallit 6**) · Mallisarja 905 (mallit 6**) · Mallisarja 906

AR54.61-D-0008A

Remove/install digital tachograph (DTCO)

3.11.10

MODEL 901.6, 902.6, 903.6, 904.6, 905.6, 906 with CODE (JD1) EU digital tachograph

MODEL 901.6, 902.6, 903.6, 904.6, 905.6, 906 with CODE (JD2) EU digital tachograph with rpm and additional recorder

Remove/install digital tachograph (DTCO)

D54.61-1152-06

1 Extractor hooks

A56 Tachograph (model 906)

P9 Tachograph (model 901.6 up to 905.6)

Removing

1

Download stored data of tachograph (A56, P9) with the aid of the workshop card

Only if a new tachograph is installed.

Upon completion of the repair work hand over the downloaded data to the vehicle operator.

2

Insert the extraction hooks (1) in the holes in the housing of the tachograph (A56, P9) and slide in as far as the stop

Installation: Remove the extraction hooks from the tachograph before installing.

3

Using the extraction hooks, pull the tachograph (A56, P9) out of the installation opening

4

Detach the tachograph wiring harness and vehicle speed sensor wiring harness from the back of the housing of the tachograph (A56, P9)

Install

5

Install the tachograph wiring harness and vehicle speed sensor wiring harness on the back of the housing of the tachograph (A56, P9)

6

Position the tachograph (A56, P9) at the installation opening and press in until it latches noticeably in the installation opening

7

Perform tachograph inspection

Only after installing a new speed sensors or tachograph sensor or a new tachograph (A56, P9).

Observe national legal requirements for tachograph testing. In the Federal Republic of Germany carry out tachograph testing in accordance with §57b of StVZO [German vehicle licensing regulations].