P54.21-2529-09
Shown on vehicle with spare tire on steel rim, code 669
1 Load compartment floor
2 Spare tire
3 Right spare tire well trim
4 Connector
5 Lugs
N10/8 Rear SAM control unit
P54.21-2530-09
Shown on vehicle with spare tire on steel rim, code 669
2 Spare tire
20 Handle
22 Vehicle jack
23 Retaining strap
24 Plastic insert
25 Mounting screw
P54.21-2531-09
Shown on vehicle without spare tire on steel rim, code 669
20 Handle
25 Mounting screw
26 Vehicle tool kit molded part
Modification notes
25.7.06 | Disconnect/connect battery ground line and carry out basic programming removed | Steps 5 and 13 |
| Remove/install | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
1 | Read out coding from rear SAM control unit (N10/8) using STAR DIAGNOSIS | Only when exchanging the rear SAM control unit (N10/8) and if it can still be read out using STAR DIAGNOSIS. | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
STAR DIAGNOSIS diagnosis system | |||
2 | Open tailgate | ||
3 | Remove luggage compartment cover | On vehicles with luggage compartment cover, code 723. | |
4 | Open load compartment floor (1) at the handle (20), fold upwards (arrow) and secure | ||
5.1 | Open retaining strap (23), take out jack (22), unscrew mounting bolt (25), lift the spare tire (2) and the plastic insert (24) under it out of the vehicle | On vehicles with code 669 spare tire on steel rim | |
When lifting out, cover the trunk sill with a rag for example otherwise the paint of the trunk sill and/or the steel rim may become damaged. | |||
5.2 | Unscrew mounting bolt (25) and lift the vehicle tool kit molded part (26) out of the vehicle | On vehicles with code 669 spare tire on steel rim | |
Lift the vehicle tool kit molded part (26) first, then lift out upwards at an angle otherwise the lugs on the bottom side may break off. | |||
6 | Remove right spare tire well trim (3) | Slip out wiring harness. | |
7 | Using a suitable tool, press the clips (5) towards the rear SAM control unit (N10/8) and pull out of the bracket | ||
8 | Unlock plug (4) and detach from rear SAM control unit (N10/8) | The number of plugs (4) can vary depending on the vehicle equipment. | |
9 | Remove rear SAM control module (N10/8) | ||
10 | Install in the reverse order | ||
11 | Code the rear SAM control unit (N10/8) | Only when installing a new rear SAM control unit (N10/8). | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
STAR DIAGNOSIS diagnosis system |
Commercially available tools
Viitatut asiakirjat
- ad0000p200004a
- ad0000p200004a
- ah5400p000101a Ohjeita elektronisten rakenneosien sähköstaattisen varauksen purkautumisen aiheuttamien vaurioiden välttämiseksi