Jacket tube
Number | Designation | Model 215 | Model 220 | ||
BA46.10-P-1005-03D | Height adjustment motor gear mechanism to jacket tube | Stage 1 | Nm | 8 | 8 |
Stage 2 | Nm | 3 | 3 | ||
Assembly note | refer to | ||||
BA46.10-P-1006-03D | Mounting to jacket tube | Stage 1 | Nm | 8 | 8 |
Stage 2 | Nm | 3 | 3 | ||
Assembly note | refer to | ||||
BA46.10-P-1007-03D | Bolt on clamping nut | Nm | 6 | 6 | |
BA46.10-P-1012-03D | Height adjustment motor gear mechanism to mounting | Nm | 10 | 10 | |
Jacket tube
Number | Designation | Model 230 | ||
BA46.10-P-1005-03D | Height adjustment motor gear mechanism to jacket tube | Stage 1 | Nm | 8 |
Stage 2 | Nm | 3 | ||
Assembly note | refer to | |||
BA46.10-P-1006-03D | Mounting to jacket tube | Stage 1 | Nm | 8 |
Stage 2 | Nm | 3 | ||
Assembly note | refer to | |||
BA46.10-P-1007-03D | Bolt on clamping nut | Nm | - | |
BA46.10-P-1012-03D | Height adjustment motor gear mechanism to mounting | Nm | 10 | |
P46.10-2087-01
Detaching
1 Unclip fore/aft motor connector (M20x1). To do so, press lug (arrow) to left.
P46.10-2096-02
2 Loosen bolts (87d) of clamp nuts (87e) and unscrew clamp nuts (87e).
3 Remove bolts (87d) with pilot bushings.
4 Remove upper bracket (71e) and mounting console (87).
Attaching
5 Fit mounting console (87) and upper bracket (71e).
6 Insert bolts (87d) and pilot bushings.
Check pilot bushings, replace if necessary.
7 Screw on clamp nuts (87e) and fit bolts (87d) of clamp nuts (87e).
The smooth surface of the clamp nut (87e) must point outwards.
8 Tighten bolts (87d), loosen again then retighten, observing the specified tightening torques.
9 Tighten bolts of clamp nuts (87e).
10 If the gearing was removed before the height adjustment motor, then the steering column tube must be aligned. Tighten the bolts (60a) on the right-hand side. Press the left side slightly to the right above the spring (arrow) using a screwdriver and tighten bolts (60a).
11 Clip in fore/aft motor connector (M20x1).