Wheel location, hub
Number | Designation | Model 171 | Model | |||
BA33.20-P-1006-01E | Self-locking nut for cross strut on front axle carrier | Stage 1 | Nm | 80 | 80 | |
Stage 2 | ° | 120 | 120 | |||
BA33.20-P-1007-01E | Self-locking nut, torque strut to front axle carrier | Stage 1 | Nm | 80 | 80 | |
Stage 2 | ° | 120 | 120 | |||
Wheel location, hub
Number | Designation | Model 209 | |||
BA33.20-P-1006-01E | Self-locking nut for cross strut on front axle carrier | Stage 1 | Nm | 80 | |
Stage 2 | ° | 120 | |||
BA33.20-P-1007-01E | Self-locking nut, torque strut to front axle carrier | Stage 1 | Nm | 80 | |
Stage 2 | ° | 120 | |||
Camber adjustments
Cross strut in mm | Camber change | Torque strut in mm | Caster change |
+4 | 40' | 0 | +16' |
4 | +40' | 0 | 16' |
Caster adjustments
Cross strut in mm | Camber change | Torque strut in mm | Caster change |
0 | 9' | +4 | 40' |
0 | +9' | 4 | +40' |
Camber and caster adjustments
Cross strut in mm | Camber change | Torque strut in mm | Caster change |
+4 | 47' | +4 | 24' |
4 | +50' | 4 | +24' |
+4 | 32' | 4 | +56' |
4 | +31́' | +4 | 56' |
P40.20-2069-08
1 Remove mounting bolt (A).
For the adjustment of camber and caster the respective mounting bolt (19a) with shims must be replaced by a repair bolt (19c) with shims. This enables an adjustment of 4 mm towards + or - to be achieved.
2 Install repair bolt (B).
When tightening the nut (19b) ensure that the repair bolt (19c) is not twisted otherwise the lugs in the inner core of the respective rubber mount will be sheared off and as a result the rubber mount becomes unusable.
Model 203.7:
If the strut rod has a rubber mount with round hole, a rubber mount with elongated hole must be installed.