Wiring harness repair kit
211 589 01 99 00
Flat conductor table
Flat conductor model | Flat conductor version | Color | Part number |
FFC | 2-pin | White | A 164 001 20 99 |
FFC | 2-pin | White | A 164 001 24 99 |
FFC | 3-pin | White | A 164 001 21 99 |
FFC | 4-pin | White | A 164 001 22 99 |
FFC | 5-pin | White | A 164 001 28 99 |
FFC | 6-pin | White | A 164 001 29 99 |
FFC | 7-pin | White | A 164 001 23 99 |
In case of repair, the flat conductor model FPC (blue) is replaced with a corresponding flat conductor model FFC (white). It is necessary to use the same flat conductor version.
Crimp contact table
Flat conductor model | Crimp contact model | optical feature | Part number |
FFC | Micro quadlock system (MQS) female contact | 2 holes in the crimp zone | A 000 982 43 26 |
FFC | Micro quadlock system (MQS) male contact | 2 holes in the crimp zone | A 000 982 14 28 |
FPC | Micro quadlock system (MQS) female contact | 4 notches in the crimp zone | A 000 982 45 26 |
FPC | Micro quadlock system (MQS) male contact | 4 notches in the crimp zone | A 000 982 12 28 |
P54.18-3896-01
1 Separate the flat conductor cable in an angle of 90° using a suitable tool.
2 Select the crimp contacts (1) in the wiring harness repair kit.
3 Open the crimp pliers . Fold down the crimp contact support (2) of the tool head , fit with the selected crimp contacts (1) and fold up the crimp contact support (2) of the tool head .
P54.18-3897-01
P54.18-3898-01
4 Slide the flat conductor cable (7) against the crimp contact support (2) of the tool head , put the marked edge to the left or right of the adjusting stop (3) and align with the aid of the optical adjusting device (4). To do this, operate the button (5) for the optical adjusting device (4) and also detach the adjusting stop (3), move and tighten.
P54.18-3899-01
The flat conductor cable (7) must make contact with the crimp contact support (2) of the tool head and the correct edge of the flat conductor cable (7) must make contact with the adjusting stop (3), otherwise mounting and polarity of the crimp contacts (1) may be incorrect. Furthermore, the flat conductor cable (7) with the optical adjusting device (4) must be aligned so that the optical adjusting device (4) is fully visible between 2 conductor tracks.
The power supply battery of the optical adjusting device (4) can be replaced in case of requirement. It is located below a cover on the underside of the tool head .
P54.18-3900-01
5 Squeeze crimp pliers until stop is reached and remove crimped connection.
The crimp pliers must be squeezed until stop is reached before they will open again.