Change software release in engine management control module (MCM) and exhaust aftertreatment control module (ACM)

SM07.15-W-0010B

Change software release in engine management control module (MCM) and exhaust aftertreatment control module (ACM)

29.10.15

Engine

936.9 in model 956

Operation no. of the operation texts or standard texts and flat rates

Category

Op. no.

Operation text

Time

Acc. no.

Code

N

029600

Update software release in engine management (MCM) and exhaust aftertreatment (ACM) control units

1,0 h

15 955 53

SENSDRIFT3

Update software release

1

Connect diagnostic system, start XENTRY and switch on ignition

 XENTRY update 12/2015 at least must be installed for the update.

2

Perform initial quick test

 The initial quick test is saved until the diagnosis session is ended.

3

Update software release in engine management control unit (MCM)

 The update procedure is completely menu-assisted under:
MCM - engine management (A4) 
Adaptations 
Initial startup 
Control module programming
If errors occur during the update, an XSF ticket with the supplementary information "CODE: SENSDRIFT3" should be generated. The supplementary information can help speed up processing of the XSF ticket.

4

Update software release in exhaust aftertreatment control unit (ACM)

 The update procedure is completely menu-assisted under:
ACM - Exhaust aftertreatment (A60) 
Adaptations 
Initial startup 
Control module programming
If errors occur during the update, an XSF ticket with the supplementary information "CODE: SENSDRIFT3" should be generated. The supplementary information can help speed up processing of the XSF ticket.

5

Delete fault memory in all control units

6

Run final quick test, print out initial quick test and final quick test and file them

 There must be no fault codes in the control units being updated. If necessary, process any fault codes in other control units, subject to a separate repair order.

7

End XENTRY and disconnect diagnostic system