ra3003d101000x

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

Type ra · topic 30.14 · version 9212 · 1992-03-18

Applies to:

Where it sits

Function group 1 Engine › 30 Throttle control, speed control systems › 30.14 Throttle control, engine side — Series 364 (models 906, 911, 912, 919, 920, 921, 950, 952, 957, 958, 981, 984, 986, 987)

30 - 1010 Adjusting accelerator control

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

Adjusting

-------------------------------

1 Warm engine up to normal operating temperature.

2 Connect revolution counter.

3 Turn idle speed regulating button fully back.

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

4 Check idle speed. Specification 600 -
650 rpm.

5 If engine speed is not achieved, adjust idle speed at pushrod of engine stop cylinder to specification.

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

Note

The idle stop must be making contact (arrow).

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

6 Run engine at full throttle and check whether the control lever at the injection pump is resting against full throttle stop.

Note

The kickdown switch must not be operated.

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

7 If the control lever is not resting against full throttle stop, adjust accelerator control linkage (arrow) accordingly.

1010 - Adjustment of accelerator control Engines 364, 364 A/LA - T2

8 On vehicles with Bowden cable, slacken lock nut at holder of Bowden cable, adjust Bowden cable accordingly, tighten lock nuts.

Note

After adjusting, repeat check of full throttle stop.

Referenced documents